User manual MUSE M-01R

[. . . ] Remark: During FM1 selected (76-90MHz) or (87-108MHz), MW frequency range will change to (522-1620kHz); If FM1 selected (88-108MHz), MW frequency will change to (520-1710kHz). 11 12 14 16 POWER SUPPLY Battery Operation 1. Remove the lid of the battery compartment 2. Before inserting the batteries, observe the polarities (+ and -) of the battery, then relate the polarities to the engraved diagram inside the battery compartment. Insert 4x R20/ SIZE “D” batteries (not supplied) into the compartment. [. . . ] GB - 1 GB - 2 LISTEN TO THE RADIO BAND SELECTION Turn on the unit. Press BAND button to select MW, FM1 or FM2 band. AUTO SCAN TUNING Press AUTO SCAN button once, the unit will auto tune into the station and will stop once station being received. You can press again to search another station. MANUAL TUNING Rotate TUNING knob to search your desired station. VOLUME & TONE CONTROL - Rotate the VOLUME control knob to your desired volume. - Rotate the TONE control knob to adjust your desired tone. USING ANTENNA - When listening to FM broadcasting, extend the ANTENNA and change its length and direction to find the position which gives the best reception. - When listening to MW broadcast, rotate the unit to find the position which gives the best reception. GB - 3 19 17 PLEASE READ THE INSTRUCTION CAREFULLY BEFORE OPERATING THE UNIT. LISTENING TO FM STEREO Press STEREO/DISPLAY button until stereo earphones for the listening. indicator appears in the display when using DELETE PRESET STATIONS DELETE SINGLE STATION 1. Press TUNING knob, the unit will display station frequency and pre-memory address (00~99), then rotate TUNING knob, find the station frequency and address which you will delete. button to have pre-memory address (00~99) flashing. The unit will pick up the next available memory address for you; or you can select your own desire memory address by rotating TUNING knob, then short press MEM. /DEL. MEMORY SEARCH Turn on the unit, short press the TUNING knob to have pre-memory address(00~99) display on the right bottom corner, and then rotate TUNING knob to select your preference stored station. MEMORY SCAN Long press TUNING knob to scan each stored stations for 5 seconds. LINE IN 1. Connect your auxiliary source (e. g mp3 player) to the LINE IN jack on the unit. 2. Start playback from your auxiliary source. 3. Disconnect your auxiliary source from the LINE IN jack to switch back to listen to the radio. Note: If no audio signal input, the unit will turn off automatically within 5 minutes. SLEEP TIMER FUNCTION 1. In OFF mode, short press POWER/SLEEP button. “SLEEP” icon appears on display. Within 3 seconds rotate the TUNING knob to adjust your desired auto turn-off time:01, 05, 10, 15, 30, 45, 60, 75, 90, 120, 150, 180, 210, 240, 270, 300, 330, 360, 390, 420, 450 or 480 minutes. RESET PROCEDURE If the radio does not function and the solutions below do not resolve the problem, perform a ‘ reset ‘. To reset the M-088R, unplug the external adaptor(if one is being used) and remove the batteries from the battery compartment. Insert a pointed object, such as straightened paper clip, into the RESET hole on front of the radio and gently press and release . [. . . ] After setting hour, immediately press the TIME button, then minute digit flashes in the display, rotate TUNING knob to change minute. After 3 seconds, it will automatically confirm the clock setting. TIMER A & B SETTING Turn off the unit, long press the TIMER A button until hour digit flashes and “A” indicator appears on the display, then rotate TUNING knob to adjust hour. After hour setting, immediately press the TIMER A button, then minute digit flashes in the display, rotate TUNING knob to adjust minute. [. . . ]