User manual MUSE ML-30 CR NATURE

[. . . ] - Never recharge, apply heat to them or take the batteries apart. - In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time. - Battery shall not be exposed to excessive heat such as sunshine, fire or the like. LCD DISPLAY LIGHTING - Your clock radio is equipped with a saving energy LED (Light Emitting Diode) main light and multicolor ambience light. Main light 1. Press button (2) once to turn on the main light. [. . . ] To check the alarm settings - Press and hold or button (11 or 10) for 3 seconds. Time, alarm source and progressive light status are displayed for the corresponding alarm. Release this button to go back to clock display. NAP FUNCTION This function wakes you up after a short period of time. Only buzzer sound is available for NAP alarm. The “NAP” icon and the current nap time flashes on display (5). During this period, adjust nap time by pressing or (13/14). If no button is pressed after 5 seconds, it will return to clock display with “NAP” icon. When the Nap alarm is triggered, press NAP (8) to stop, “NAP” icon will disappear. To check the remaining time before the NAP alarm is triggered, press NAP button (8), ON/OFF (12), or button (3). To cancel NAP function before NAP alarm is triggered, press NAP button (12), adjust nap time to “00” by pressing or (13/14), it will return to clock display after 5 seconds, “NAP” icon disappears. MORE INFORMATION ATTENTION : To reduce the risk of electric shock, do not remove the cover. There are no user serviceable parts inside the unit. Refer all servicing to qualified personnel. The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of “dangerous voltage” inside the The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product. WARNING - To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. SETTING THE ALARM AND WAKE-UP MODE This unit allows two wake times and to set the main light to turn on automatically and progressively a certain time before the alarm triggers. To set the alarm time -Slide the setting mode switch (6) to (alarm1) or (alarm2) position, “AL 1” or “AL 2” will appear on display and the HOUR digit will flash. The time decrements or increments at a faster rate when you press and hold the buttons. -Press button (3) and the MINUTE digit will flash, press / (13/14) to adjust. To set the progressive light (with setting mode switch (6) on or position) -Press button (1) repeatedly to adjust the progressive light activated duration (OFF-05-10-15-20-OFF) before alarm triggers. NOTE: When set to “OFF”, the main light will remain switched off at wake-up, “ ” is not displayed. 3. When alarm time and progressive light settings are completed, slide the setting mode switch (6) to (lock) position. To select the alarm source (buzzer or radio/natural sound) - Press or button (11 or 10). 1st press:” ”/“ ” (wake up by buzzer) 2nd press: “ ”/” ” (wake up by radio/natural sound) 3rd press: alarm off NOTE: Waking up by FM/MW radio or natural sound depends on position (FMMW) of the sound mode switch. STOPPING THE ALARM The alarm is programmed to run for 59 minutes. [. . . ] - Do not use your set immediately after transport from a cold place to a warm place, there may be condensation problems. - Make sure that you keep your set away from water and high temperatures. - Clean the player with a soft cloth, or damp chamois leather. - To be completely disconnected the power input, the mains plug of the apparatus shall be disconnected from the mains completely. [. . . ]