User manual MUSIC HALL USB-1

[. . . ] music hall usb-1 INSTRUCTION MANUAL music hall http://www. musichallaudio. com IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions ­ All the safety and operating instructions should be read before this product is operated. Retain Instructions The safety and operating instructions should be retained for future reference. Heed Warnings All warnings on the appliance and in the operating instructions should be adhered to. [. . . ] White (L+). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Left channel+ Blue (L-) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Left channelRed (R+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Right channel+ Green(R-) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Right channel(b) Install the cartridge to the headshell and tighten it with screws provided with the cartridge. Insert the headshell into the front end of the tonearm, and then turn the lock nut counterclockwise with the headshell firmly held horizontally. Twist it lightly and it will screw onto the rear shaft of the tonearm. Adjustment of horizontal "zero" balance and stylus pressure: (a) Remove the stylus protector from the headshell; do not touch the stylus tip during the adjustment. (b) Set the cueing lever to the lowered position. (c) Release the tonearm clamp and lift the tonearm from the armrest to free it. (d) Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely). (e) Refasten the tonearm with the tonearm clamp. (f) Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "0" of the ring into alignment with the centerline on the tonearm rear shaft. (g) Rotate the counterweight including the stylus-pressure ring counterclockwise until the scale shows the value corresponding to the pressure of the stylus used(3g). Should you use a separate Stylus, please follow the manufacturer's instructions. Set the anti-skating control knob to the same value as the stylus pressure. Install the dust cover to the main unit's dust cover hinges. PLACEMENT Do not place the unit in a location where it will be exposed to direct sunlight or near a heating appliance. Do not place the unit in a location where there is high humidity or a lot of dust. Cartridge may pick up slight sound pressures or vibrations of the speakers coming along the floor or through the air resulting in feedback or "howling" sound. Find a location that is very stable and vibration free. The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body horizontally. 3 CONNECTIONS Before connecting the unit it is advised that you also consult your current equipment instruction manual. IMPORTANT : Be sure to turn off the equipment before you make changes to the different connections. [. . . ] Check the box marked Play other tracks while recording new one. Check the box marked Software Playthrough. 7 Recording Albums with Audacity 1. Saving a project Audacity writes all the changed and recorded audio to a directory called Projectname_data, which is located right where you saved the project file itself. Thus, select Save project as from your Audacity File tab and choose a location and filename for your project. [. . . ]