User manual NAD 302

[. . . ] It has a database of remote control commands built-in for a large range of different brands and devices. In case your particular brand or model isn't featured in the database, the HTR-1 can also "learn" remote commands from the original remote control of the device. Refer to the HTR-1 instruction manual on how to program. The table below indicates the locations and functions available; the numbers refer to the drawing in the NAD 302 manual. [. . . ] The STATUS LED will change to red again. 2) and hold down for 2 seconds then release for 2 seconds. Repeat this process until the TV switches off or switches to Stand­by. 5 Press the lit DEVICE KEY once, and now try the other function keys on the HTR-1. Switch the TV back on (if it switched off completely, it may be necessary to this manually) and try out all the keys appropriate for your TV; such as Volume Up/Down; Channel Up/Down; Mute, etc. · If you find not all keys operate your TV correctly, press the DEVICE Key for 1 second; the DEVICE Key will flash once. Repeat step 4 until you find the set of remote commands that best operates your TV. Once found, proceed with step 6 to store. 6 If all major functions work, press the TUNER/TV key 3 times; The TUNER/TV device key and STATUS LED will extinguish. The code is now stored and the remote control is ready for use with the TV. When you reach the end of the library, The STATUS LED will flash twice per second and the set up mode is cancelled. GB 7 ENTERING MANUFACTURER ID CODE Instead of searching the library, you can also enter a Manufacturer ID code directly for your brand and model. Press 88888 to check the code for any other devices (CUSTOM). If the entered code is correct, the STATUS LED will flash once. If the code is wrong, the STATUS LED will flash twice. To find out the number for the first digit of the code, press 1 on the Numeric keypad (No. 10) and count the number of times the DEVICE flashes. To find the 2nd digit of your code press 2, for the 3rd digit press 3, for the 4th digit press 4 and for the 5th digit press 5 and each time count the number of times the DEVICE key flashes. NOTE: IF the DEVICE key doesn't flash, the digit's number is zero. Press the DEVICE key to exit Code Recall mode. The DEVICE key will extinguish. 4 5 In case the HTR-1 gets accidentally re-programmed, it is advisable to note down in the table below which exact codes were set up to operate your devices. Device AMP TUNER CD DVD code Device VCR TV CABLE CUSTOM code You can use the recalled device code to enter it directly into the HTR-1; this voids the need of having to go through each separate device within a manufacturer ID code: 1 2 3 4 Press the POWER ON/OFF (No. 14) together for approximately 2 seconds until STATUS LED (No. 1) stays red. Press the required DEVICE key (No. 3); the DEVICE key will light up. [. . . ] If the entered code is correct, the STATUS LED will flash once. If the code is wrong, the STATUS LED will flash twice. 4 Record your Macro by selecting the functions you wish to carry out when Macro is selected, just as if you were using the remote control. You can switch devices to have remote commands from other devices within the same Macro. [. . . ]