User manual NAD 6125

[. . . ] It should not be placed directly on a loudspeaker, a television set, or a large power amplifier where it might pick up hum from the amplifier's power transformer. If you wish to install the recorder next to an amplifier on the same shelf, place the recorder on the left so that its cassette compartment will be located away from the amplifier. If this appartus is not fitted with a UK three-pin plug, do not attempt to insert the attached plug into a UK mains socket. Instead, cut the plug from the mains lead and attach a fused UK three-pin plug using the following safety advice on wiring. [. . . ] If you wish to interrupt play-back or recording for a moment, use this button. Press Play again to resume playing back or recording. The cassette tape must be inserted into this compartment. use the "OPEN" button to open the compartment. With a gentle push, until a click is heard, the compartment can be closed. This button will stop all tape transport functions such as play, record, fast forward and rewind. To load a cassette tape, remove it from its protective jewel case. Before inserting the cassette, ensure the tape is straight and taut where it is exposed at the thick edge of the cassette. If necessary, insert a pencil into either hub With the function you can rewind the tape from right to left. Fast rewind is stopped automatically once the beginning of a tape is reached or if REPEAT Block had been engaged and the tape has reached the beginning of the block (see also section "REPEAT" (16) of this chapter). You can stop rewind manually by using the STOP button. Refer to chapter "Getting the best performance from your NAD 6125 cassette deck" section "Bias control" for more information. Play Trim is a special play-back equalisation circuit to restore accurate play-back response from prerecorded, old and worn tapes, tapes recorded in another deck, tapes which weren't recorded properly (too much or too little bias). This control will allow you to adjust the deck's circuitry to ensure proper Dolby NR tracking for a correct high frequency response. Refer to chapter "Getting the best performance from your NAD 6125", section "The Play Trim control" for more detailed information. The NAD 6125 is equipped with two repeat modes; repeat the entire side of a cassette or repeat a preselected block 5 times. Select FULL (either from stop or during playback) to repeat the entire cassette. Press the PLAY button again to mark the beginning of the block. You can press PLAY again to change the beginning of the block. When you have reached the end of the block you wish to repeat, press the REWIND button (8). The block indicator stops flashing and remains lit until the pre-selected block has been repeated five times or STOP is pressed. The counter can be re-set at any point while a tape is playing to mark a particular place on the tape. [. . . ] Parts in direct contact with the tape therefore need to be cleaned regularly. NOTE: Make sure the receiver or amplifier is switched off before cleaning or demagnetising the heads. Whilst making a new recording any previous recordings already on the tape will automatically be erased. If you wish to protect a tape from being erased or re-recorded accidentally, you can remove the tape's protection tabs. [. . . ]