User manual NAD 613

[. . . ] Note to CATV system installer: This reminder is provided to call the CATV installer's attention to Section 820-40 of the NEC , which provides guidelines for proper grounding and, in particular, specifies that the cable should be connected to the grounding system of the building, as close to the point of cable entry as practical. Some models are designed for use only with the power supply voltage of the region where they are sold. The lightning flash with arrowhead, within an equilateral triangle is intended to alert the user of the presence of uninsulated "dangerous voltage" within the product's enclosure; that may be of sufficient magnitude to constitute a risk of electric shock to persons. The recorder may be installed on any stable surface that is not subjected to vibration or intense magnetic fields. [. . . ] With the function you can wind the tape forward from left to right. Fast forward is stopped automatically once the end of a tape is reached. You can stop fast forward manually by using the STOP button. This button, when pressed together with either the PLAY or PAUSE button, will activate the recording circuits. The "Record" annunciator with either play or pause icon will light up in the display. By pressing PLAY in combination with RECORD, the recording will start immediatly; by pressing PAUSE with RECORD only the recording circuits will be activated. by subsequently pressing PLAY recording will start. Now the "Record" annunciator together with the play icon in the display will light up to indicate the recording status. Set the DOLBY NR (17) selector to the desired type of noise reduction (no noise reduction; OFF, B or C). do not change the Dolby NR setting whilst the deck is recording. Refer to the chapter "How to get the best performance from your NAD 613 cassette deck", section "The Dolby NR noise reduction systems B & C" for more detailed information. Press the RECORD (10) button together with the PAUSE (7) button; the red annunciator and pause icon in the display will light up. Refer to chapter "How to get the best performance from your NAD 613 cassette deck", section "Recording level" for more information. If you wish to interrupt a recording whilst keeping the recording circuits and display active, press the PAUSE (7) button. When you are ready to resume recording press PLAY (6). This technique is useful for omitting announcements or commercials when recording from radio or television. The recording balance between left and right channel can be adjusted using this control. Normally this control is set at the 12 o'clock position. Refer to chapter "How to get the best performance from your NAD 613 cassette deck", section "Recording level" for more information. The Bias tuning control allows you to compensate for almost any brand-to-brand difference in tape sensitivity and frequency response. Turning the control clockwise will decrease treble (more Bias), turning it counter clockwise increases treble response (less Bias). Normally this control should be at the "0" position (centre detent). [. . . ] This way the record function will not engage. please note that most prerecorded tapes commercially available already have the tabs removed. Using adhesive tape over the holes will enable the circuits to record again. crO2 (type II) and Metal (type IV) tapes have additional holes in the cassette housing , enabling the deck to "recognize" the various tape types. [. . . ]