User manual NAD 710

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitutet a risk of electric shock to persons. If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc. Any outdoor antenna must be located away from all power lines. [. . . ] Have the unit inspected by a qualified service technician before attempting to use it again. Do not remove the cover, there are no user-serviceable parts inside. If necessary, lightly dampened the cloth with soapy water. Do not use solutions containing benzol or other volatile agents. Use a twin RCA-to-RCA lead to connect the left and right analogue Audio Outputs of a CD player to this input. Input for the audio signal from a stereo VCR (or stereo TV/Satellite/Cable receiver) or other line-level audio source. Using twin RCA-to-RCA leads or a SCART/RCA Adapter, connect to the left and right `Audio Out' of the unit to these inputs. Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. A ribbon wire FM antenna is included and should be connected to the FM connector at the rear of the unit using the `balun' adapter supplied (see fig 1). the ribbon aerial should be mounted on a vertical surface and placed so that it forms a `T'. Experiment with placement of the antenna to find the position that gives the best signal strength and lowest background noise. An inadequate FM signal normally results in high levels of hiss, especially in stereo, and interference from external electrical sources. The tuner section's performance can be improved by using an externally mounted FM antenna. A qualified aerial installer will be able to advise and fit a recommended aerial for your reception conditions. Using twin RCA-toRCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE IN connectors for playback and tape monitoring. The `RIGHT+' terminal should be connected to the `+' terminal on your right-hand loudspeaker and the `RIGHT-' connected to the loudspeaker's `-' terminal. connect the terminals marked `LEFT+' and `LEFT-' to the left-hand speaker in the same way. Always use heavy duty stranded wire or specialist speaker cables to connect the loudspeakers to your NAD-710. The high-current binding post terminals can be used as a screw terminal for cables terminating in spade or pin connectors, or for cables with bare wire ends. These should be slotted under the terminal's screw bushing, which is then fully tightened. Ensure the connector is tightly secured and there is no danger of bare metal from spade connectors touching the back panel or another connector, as this may cause damage. [. . . ] Note: Copying may be violating the copyright or property rights of the recordings owner. It will be released when a different input is selected. Use Mono mode when the signal is present on only one of the two stereo input channels (left or right) or when receiving weak and hissy stereo FM signals. The outer ring controls the level to the right-hand speaker and the inner section controls the level of the left-hand speaker. [. . . ]