User manual NAD 711

[. . . ] If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc. The graphic symbol of a lightning flash with an arrow point within a triangle signifies that there is dangerous voltage within the unit and it poses a hazard to anyone removing the cover to gain access to the interior of the unit. Only qualified service personnel should make any such attempt. If an outside antenna is connected to your tuner or tuner-preamplifier, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. [. . . ] To decode correctly, the video or TV signal must be of a Dolby Surround or Dolby Stereo soundtrack and coming from a stereo VCR, TV or satellite/cable receiver. HALL mode produces a surround sound effect from a normal stereo source such as a CD or FM radio. bY-PASS switches to normal Stereo operation. The selected mode is displayed in the main area of the Display Panel for 3 seconds and is continuously shown in Surround Mode area of the Display Panel. As an additional convenience feature, your AV 711 memorizes which surround mode you have used with the given input selection. When you next select that input, your AV 711 will automatically choose the same Surround mode again. If you normally use Dolby Pro Logic mode on the Video 1 and Video 2 inputs, Dolby 3 Stereo mode on the Video 1 input, Hall mode on FM, and By-Pass (Stereo) on the others, pressing the Input Selector will automatically default to the right Surround mode without having to separately press the Surround Mode button. The Display Panel shows the frequency of the tuned station and which Preset and Preset bank (if any) is selected. /2 second puts the tuner section into Search mode. It will search through the tuning frequencies and stop when it finds a broadcast station. Pressing the CENTER button pages through the three options: NORMAL, PHANTOM and WIDEBAND. For Dolby Pro Logic use NORMAL, WIDEBAND, PHANTOM and for Dolby 3 Stereo use NORMAL, WIDEBAND. NORMAL mode is used when the center speaker is smaller than the front left and right speakers. This mode produces a true center image with the very low frequencies (below 70Hz) filtered out. WIDEBAND mode is used when the center speaker is the same type as the front left and right speakers. The 30 Presets can be AM or FM stations and are stored in three Preset Banks, which can contain up to 10 Preset stations. Press BANK to switch between the three banks (A, B or C) of tuner presets. For convenience you could use two Banks for FM stations and one Bank for AM, although a mix of FM and AM stations can be stored in any single Bank of presets. Using the remote control; press the BANK button and choose the bank group, and then press the PRESET (+ or ­ button). In normal (FM MUTE ON) operation, during the tuning process the tuner will mute when there is little or no signal present, giving silence until a station with a reasonably strong signal is found. Pressing FM MUTE/MODE will switch off the mute function so that very weak stations can be located. fM MUTE OFF also switches off the FM stereo function. [. . . ] But in some rooms reversing the connections may produce a noticeable increase in bass response or an improvement in overall stereo imagery, so you may wish to experiment with revers- As well as the standard audio sources, this system has also a VCR, a Laser Disc player or a games console connected as A/V sources. the SUB WOOFER OUT is connected to a self-powered sub-woofer. The AV 711 is also connected to a second audio system in another room. The VCR machine is connected to VIDEO 2 which has audio/video INPUTS and OUTPUTS to enable recording from the other video sources. [. . . ]