User manual NAD C165BEE

[. . . ] ® Owner's Manual Stereo Preamplifier C 165BEE SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH IMPORTANT SAFETY INSTRUCTIONS ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA Save theSe inStructionS for later uSe. follow all warningS and inStructionS marked on the audio equipment. 1 read instructions - All the safety and operating instructions should be read before the product is operated. 2 retain instructions - The safety and operating instructions should be retained for future reference. [. . . ] 8 tuner input: Input for a tuner or other line-level signal source. Use a twin RCA-to-RCA lead to connect the tuner left and right "Audio Outputs" to this input. 9 mp input: Input for a Media Player or other line-level signal source. Use a twin RCA-to-RCA lead to connect the Media Player's left and right "Audio Outputs" to this input. 10 aux input: Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right "Audio Outputs" to this input. 11 tape 2 in/out: Connections for analog recording and playback to an audio tape recorder of any type. Using twin RCA-to-RCA leads, connect to the left and right "Audio Output" of the tape machine to the TAPE 2 IN sockets for playback. Connect the left and right "Audio Input" of the tape machine to the TAPE 2 OUT sockets for recording. SVENSKA NEDERLANDS DEUTSCH ITALIANO 1 mc loadS (r1, r2, r3): If you are using a Moving Coil (MC) cartridge, set this switch to a resistive load that closely approximates the value specified in the MC cartridge (this is usually specified in the MC cartridge). In general, use the lowest resistance for low output cartridges and high resistance for medium output cartridges. For very high output models up to 1 mV/cm/sec and internal resistance as high as 200 ohms, use the low or medium input resistance as you may otherwise run into overload. 3 mc input: Input for a Moving Coil phono cartridge. Connect the twin RCA lead from your turntable to this input if you are using a Moving Coil cartridge. 4 mm input: Input for a Moving Magnet phono cartridge. Connect the twin RCA lead from your turntable to this input if you are using a Moving Magnet cartridge. ESPAÑOL ATTENTION! PleasemakesurethattheC165BEEispoweredofforunpluggedbeforemakinganyconnections. Itisalsoadvisabletopowerdownorunplugall associatedcomponentswhilemakingorbreakinganysignalorACpowerconnections. FRANÇAIS ENGLISH IDENTIFICATION OF CONTROLS rear panel ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA 12 tape mon. in/out: Connections for analog recording and playback to a secondary audio tape recorder of any type. Using twin RCA-to-RCA leads, connect to the left and right "Audio Output" of the tape machine to the TAPE MONITOR IN sockets for playback and tape monitoring. Connect the left and right "Audio Input" of the tape machine to the TAPE MONITOR OUT sockets for recording. to make a recording When any source is selected, its signal is also fed directly to any tape machine connected to the TAPE 2 OUT or TAPE MONITOR OUT for recording. tape to tape copYing You can copy between two tape machines connected to your NAD C 165BEE. Put the source tape in the recorder connected to Tape 2 and the blank tape into the recorder connected to Tape Monitor. By selecting TAPE 2 input you can now record from Tape 2 to Tape Monitor and monitor the signal coming from the original tape. [. . . ] · Battery flat or incorrectly inserted. · IR transmitter or receiver windows obstructed. · IR receiver in direct sun or very bright ambient light. poSSible SolutionS · Check if AC lead is plugged in and power switched ON. [. . . ]