User manual NAD C300

[. . . ] Retain this notice and the owner's manual for future reference. All warnings on the unit and in its operating instructions should be adhered to. Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool. The unit should be installed so that its location or position does not interfere with its proper ventilation. [. . . ] Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. Use a twin RCAto-RCA lead to connect the CD player's left and right `Audio Outputs' to this input. The NAD C300 only accepts analogue signals from your CD player. VIDEO INPUT Input for the audio signal from a stereo VCR (or stereo TV/Satellite/Cable receiver) or other line-level audio source. Using twin RCA-to-RCA leads, connect to the left and right `Audio Out' of the unit to these inputs. AUX INPUT Input for additional line level input signals such as another CD player. Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and right `Audio Outputs' to this input. Use a twin RCAto-RCA lead to connect the Tuner left and right `Audio Outputs' to this input. Using twin RCA-to-RCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE 2 IN sockets for playback and tape monitoring. Using twin RCA-to-RCA leads, connect to the left and right `Audio Output' of the tape machine to the TAPE 1 IN sockets for playback and tape monitoring. 5mm , or thicker) stranded wire to connect loudspeakers to your NAD C300. The high-current binding post terminals can be used as a screw terminal for cables terminating in spade or pin sockets or for cables with bare wire ends. BARE WIRES AND PIN CONNECTORS Bare wires and pin sockets should be inserted into the hole in the shaft of the terminal. Unscrew the speaker terminal's plastic bushing until the hole in the screw shaft is revealed. Insert the pin or bare cable end into the hole and secure the cable by tightening down the terminal's bushing. Ensure bare wire from the speaker cables does not touch the back panel or another socket. Ensure that there is only 1/2" (1cm) of bare cable or pin and no loose strands of speakers wire. AC LINE CORD Plug the AC power cord into a live AC wall socket. Make sure all connections have been made before connecting to mains. POWER Pressing the POWER switch turns the unit On. The LED will light up red initially and within seconds will turn green. Pressing the POWER switch again will turn the amplifier Off. [. . . ] Put the source tape in the recorder connected to Tape 2 and the blank tape into the recorder connected to Tape 1. By selecting TAPE 2 Input you can now record from Tape 2 to Tape 1 and monitor the signal coming from the original tape. REMOTE CONTROL HANDSET MUTE Press the MUTE Button to temporarily switch off the sound to the speakers and headphones. Mute does not affect recordings made using the Tape outputs. [. . . ]