User manual NAD C372

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Do not place this unit on an unstable cart, stand or tripod, bracket or table. [. . . ] 2) over the power button will light up amber and after a short pause will turn to green to indicate the amplifier is now ready for normal operation. Pressing the POWER switch again will turn the unit OFF completely, it will not respond to the remote control. 2) over the power button will light up amber. Pressing the POWER switch again will turn the unit OFF completely, it will not respond to the remote control. the NAD C 372 remote has a separate On and Off button. This can be particularly useful to keep components within a system "in sync": This way all components will switch to standby when Off is pressed or switch to operating mode when On is pressed, instead of some components switching On when the amplifier is switched to Stand-by. 2) will turn from amber to red, then to green and the indicator for the last selected input will blink and light up. Press the OFF button to switch the unit to the Stand-by mode: The Stand-by indicator will light up amber. nOTE: In Stand-by mode the C 372 uses very little power. However, it is recommended that you switch the unit totally off if it is not going to be used for more than a couple of days. Switch off completely by pressing the POWER button on the front panel (No. POWER / STAND-BY / PROTECTION INDICATOR Upon switching the power on, the LED will light up amber in standby state. While one of the input select buttons is pressed, the LED will turn red for a moment, then turn green for ON state. In cases of serious abuse of the amplifier, such as overheating, excessively low loudspeaker impedance, short circuit etc. The amplifier will engage its Protection circuitry, indicated by the LED turning from green to red, and the sound being muted. In such a case, turn the amplifier off, wait for it to cool down and/or check the speaker connections, making sure the overall loudspeaker impedance doesn't go below 4 ohms. Once the cause for the protection circuitry to engage has been removed, press Power again to resume normal operation. HEADPHONE SOCKET A 1/4" stereo jack socket is supplied for headphone listening and will work with conventional headphones of any impedance. Use a suitable adapter to connect headphones with other types of sockets, such as 3. 5mm stereo 'personal stereo' jack plugs. NOTE: Make certain that the volume control is turned to minimum (fully counter-clockwise) before connecting or disconnecting headphones. Listening at high levels can damage your hearing. [. . . ] Anslut ett par signalkablar till höger och vänster "Audio Input" kontakt på effektförstärkaren eller processorn till "PRE OUT" kontakterna. oBSERVERA att nivån på "Pre Out" signalen följer inställningen på volymreglaget och tonkontrollerna. Tänk på att se till att alla apparater är avslagna innan några anslutningar görs till PRE OUT 1 & 2 och MAIN IN. Anslut ett par signalkablar till höger och vänster "Audio output" kontakt på effektförstärkaren eller processorn till "PRE OUT" kontakterna. [. . . ]