User manual NAD C440

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Do not place this unit on an unstable cart, stand or tripod, bracket or table. [. . . ] OUTPUT Using twin RCA-to-RCA leads, connect to the left (white) and right (red) audio outputs to the `Tuner' input or other line-level input such as `Aux' input of your amplifier. The Display Panel shows the frequency of the tuned station and which band is selected. BANK Pressing Bank switches between the C440's three Preset Memory Banks (A, B or C). Each of these banks can hold up to 10 Preset stations. These Banks can contain a mix of AM or FM stations each. the Bank selected is shown in the Display Panel. You can use the banks to sort your Presets, for instance by station type (Bank A for rock/pop; Bank B for Classical music; Bank C for Jazz). NAD-LINK IN OUT The NAD-Link connector is used to pass commands from other units fitted with NAD-Link connectors. This allows centralised control of a complete system, and also allows some of the basic functions of the NAD C440 to be controlled using a NAD-linked amplifier's remote control or gives system control from more than one room. To function with such other units, connect the Tuner's NAD-Link IN to the NAD-Link Out on the other unit. NAD-Link connectors can be daisy-chained, IN to OUT, so that a whole system can be controlled from the remote control facilities of one unit. AC LINE CORD Plug the AC power cord into a live AC wall socket or to an AC convenience outlet at the rear of your amplifier. Pressing the power switch turns the Tuner on, indicated by the Display Panel becoming active. Pressing the POWER button again will switch the unit off. the C440 uses a memory back-up system to store Preset information. This information is retained for several weeks, even if the unit is switched off completely or unplugged. NOTE: When switching power On, the C440 will go back to the station last tuned to before the unit was turned off. This will allow you to make timer recordings using an external timer and recorder. SEARCH/PRESET The Search/Preset button scrolls between three different tuning modes, each successive push of the button engages the next one of the three modes. A) Preset mode: In this mode you can use the Tune/Preset button (No. When Preset Mode is selected "PRESET" lights up in the display. B) Search mode: By pressing the Tune/Preset button (10) or you can engage automatic tuning respectively up or down the frequency band . [. . . ] When tuned to a non-RDS station The Display button toggles the display to show either the station frequency or user entered station name. The Memory Presets have a memory backup, so they will remain stored for several weeks even if the Tuner is switched off or unplugged from the mains supply. NOTE: You can enter a new station into an unused Preset or overwrite an existing programmed Memory Preset. By doing this you will replace all the data previously held on that Preset number. [. . . ]