User manual NAD C520

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shcok to persons. If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc. Any outdoor antenna must be located away from all power lines. [. . . ] Press STOP if you want to end play and re-set the pickup to the beginning of the disc. Connect a cable from these jacks to your amplifier. plug one end of a stereo audio cable into the L (upper) and R (lower) output jacks. Connect the other end of the cable to your stereo amplifier's CD input, or to any other `line-level' input jacks (such as the AUXiliary inputs). The serial data output is taken after the error correction but before the digital-to-analogue conversion and filtering. the output is transformer-isolated from the built-in D-to-A circuits. It may be connected to any digital signal processor that conforms to the Sony/Philips (SPDIF) standard. To use the digital output, connect a cable from this NAD 4 Two vertical bars indicate that the player is in PAUSE. In STOP mode the display reverts to showing the number of tracks and total playing time of the disc. `no diSC' glows in the display when no disc is present or when you load a disc that cannot be read (because it is dirty or is upside-down). REPEAT ONE glows in the upper-left corner during repeat-play of a single track. REPEAT ALL glows during repeat-play of the entire program or disc REMAIN glows in the top centre area of the display if you have pressed the TIME button to show the remaining time in the disc. As each track is played its number is blanked out on the Track Listing, giving a simple indication of how much of the disc has been played and how much remains. An infrared sensor, located at the right-hand portion of the display window, receives commands from the remote control. There must be a clear line-of-sight path from the remote control to this window; if that path is obstructed, the remote control may not work. The TIME button has two modes, as follows: TIME: the elapsed time since the beginning of the current track, in minutes and seconds. (This is the `default' setting, selected automatically when the player is turned on. ) REMAIN: the total playing time that remains until the end of the disc and the total number of remaining tracks (including the current track). This button stops play, cancels any repeat-play cycle, and re-sets the pickup to the beginning of the disc. The display reverts to showing the number of tracks and total playing time on the disc. Press the Repeat button once to select the REPEAT ONE mode, in which only the current track is repeated over and over again. Pressing the Repeat button once again selects the REPEAT ALL mode, in which the entire disc is played from beginning to end, over and over again. [. . . ] Do NOT use conventional LP record-cleaning products (cleaning solutions, sprays, treated cloths, or anti-static preparations), nor any kind of chemical solvent (alcohol, benzene, et al). A severely soiled disc may be washed in a warm-water spray, possibly with a small Amount of a mild kitchen detergent added, and then wiped dry with a clean, soft towel. When cleaning the disc, use only RADIAL strokes (from center to edge). Never use a circular wiping motion like that used for cleaning ordinary LP records, because in wiping the disc there is a risk of scratching it. [. . . ]