User manual NAD L40

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shcok to persons. If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc. Any outdoor antenna must be located away from all power lines. [. . . ] NOTE: The Store mode will automatically cancel itself after approximately 5 seconds if no other buttons are pressed. IN CD MODE: The L 40 CD receiver allows you to pre-program the CD player to skip the tracks of a CD you do not want to hear (negative programming). Programming the CD player can only be done with a CD present in the tray and in Stop mode. Use the SKIP/PRESET buttons to choose the track you do not want to play; the track number is blinking in the display. The display confirms this first track cancellation by indicating "P--01". Press RANDOM either from the Stop or the Play mode and the L 40 will start to play the tracks on the CD in random order until all the tracks have been played. Press the RANDOM button again to cancel random play and return the L 40 to the normal Play mode. RANDOM can be used together with the REPEAT ALL mode. The L 40 will continue with another cycle of random playback after completing a cycle of random playback. NOTE: RANDOM can not be used together with "Program Play" (refer to section No. IN TUNER MODE: Many people find it difficult to remember which radio station belongs to what frequency. To avoid such confusion, you can give each preset a name of up to 8 characters. When calling up that preset, the name instead of the frequency will be displayed. 30 corresponds to BBC Radio 3; in this case the preset can be programmed to display "BBC R3" whenever it is called up. There are two ways to name a preset; name and store the station in a preset at the same time, or name an already occupied preset. TO NAME AND STORE A PRESET Tune into the desired radio station using the SEARCH/TUNE control buttons (No. Press the REPEAT button, apart from a flashing line, the display will go blank. Within the default time of 10 seconds you can now enter the first desired character. Select the character using either one of the SKIP/PRESET control buttons (No. Pressing the right SKIP/PRESET control button will scroll through the available characters in numeric and alphabetic order: (blank space) > 0 > 1 > 2 > 3 through to 9 > A > B > C through to Z > (blank space) > 0 > 1 > 2 > and so on. Press the left SKIP/PRESET control button to scroll through the characters in reverse order: Z > Y > X through to A > 9 through to 3 > 2 > 1 > 0 > (blank space) > Z > Y > X > and so on. 17) control button to move to the next position on the right to enter the second character and repeat selecting a character as described above. [. . . ] So a scratch that cuts through the label may damage the disc more than a similar scratch on the transparent 'playing' surface. Thus you should treat both surfaces of the disc with care. ) Severe scratches or fingerprints may cause the player to mis-track (skipping ahead, or repeating the same passage). Less severe damage may produce very brief bursts of high-frequency noise. [. . . ]