User manual NAD M15

[. . . ] M15 02 23 2006. qxd 3/7/2006 9:04 AM Page 1 ® AV Surround Sound Preamplifier SVENSKA Owner's Manual Manuel d'Installation Bedienungsanleitung Gebruikershandleiding Manual del Usuario Manuale delle Istruzioni Manual do Proprietário Bruksanvisning PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH M15 M15 02 23 2006. qxd 3/7/2006 9:04 AM Page 2 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS · Save these instructions for later use. · Follow all warnings and instructions marked on the audio equipment. 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference. [. . . ] Just pressing the key momentarily will only change the active device. RENAME All keys can be renamed except the MACRO key. In the RENAME menu, first press the DEVICE SELECTOR key then the function key; the second line of the LCD will be blank ready to accept the alpha-numeric characters. Use the navigation arrows to select the alphanumeric characters, and then press the ENTER key. Select "Save" and then "Yes" to store the new name. Note: There are a maximum of eight segments available for the alpha-numeric characters. MACRO While recording macros, the HTRM will function as normal except there will be a small "M" in the top right of the LCD display, and IR commands are transmitted the same as during normal operation. Macros will be executed with the same timing as they were recorded. The length of time each command is sent will also correspond to the length of time the key was held down for while recording. By default, when a macro is executed, the currently selected device will be returned to what it was before the macro was executed. However, if the very last button pressed while recording a macro is a DEVICE SELECTOR key, the device will be changed at the end of executing the macro. RESET Selecting this option and answering "Yes" to both confirmations will reset all HTRM options to the factory default values. Note: resetting the HTRM to the factory default settings will erase all user configurations, macros, and custom device programming. M15 02 23 2006. qxd 3/7/2006 9:06 AM Page 21 Identification of controls ABOUT THE HTRM USB INTERFACE The HTRM allows one to upload and download the configuration through a Windows PC and NAD's Proprietary HTRM programming software. See Figure 8 on how to connect an USB A male to mini USB B male 5-pin cable to the HTRM. NOTES: Please log onto www. nadelectronics. com for the latest HTRM interface control software. Use an USB A male to mini USB B male 5-pin cable between your Windows® PC and the HTRM. Your custom installer or dealer can assist you in the proper setup and configuration of the mini USB interface and software. The mini USB B male 5-pin cable is not supplied with the HTRM. Your custom installer or dealer can assist you in the procurement of the USB A male to mini USB B male 5-pin cable. Figure 8 21 SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH M15 02 23 2006. qxd 3/7/2006 9:06 AM Page 22 Identification of controls ABOUT THE M15 REAR PANEL CONNECTIONS AND CONTROLS WARNING!Make all connections to your M15 surround sound preamplifier with the unit powered off and unplugged from the AC power. Furthermore, unplug all auxiliary components' AC power before making or breaking any signal connections. [. . . ] · From the HTRM, navigate to the "COPY TO PRESET #" and then press . Then using the HTRM's arrows select the target A/V Preset number. Press ENTER from the HTRM remote control. Notes: The user's calibrated A/V system is always A/V PRESET 1. [. . . ]