User manual NAD M3

[. . . ] 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference. 3 Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA 2 4 Follow Instructions - All operating and use instructions should be followed. [. . . ] The variables are; lowercase letters, uppercase letters, numbers, and miscellaneous punctuation symbols. Record each name you assign into the chart on page 17 to aid you for future reference in the event you wish to change the hook-up and assignment of the inputs. Record / Z2 (second zone output): Press the record / Z2 button to select the input as the recording source. A press longer than one second will advance the source selection to the next input as follows; OFF, DISC, CD, TUNER, INPUT 4, INPUT 5, INPUT 6, BALANCED, LOCAL, and then return to OFF. Release the record / Z2 button to stop the sequence. furthermore , the ZR3 remote control will allow direct selection of inputs (see ZR3 Remote Control). NOTE: The record / Z2 can monitor all inputs. The record / Z2 will maintain its last state even if the M3 is set to standby. The M3 must be in its on state in order to use the record / Z2. For example, use the Mono mode to check the speakers phase. Setting the mode to Left or Right allows one to easily balance left signal inputs with right signal inputs. Press the mode button to toggle through the four listening modes. A press longer than one second will advance the mode selection to the next state as follows; STEREO, MONO, LEFT, RIGHT, and then return to the STEREO listening mode. Both LEFT and RIGHT levels are adjustable between +/- 9. 5 dB To adjust balance; press the balance button once and then within 5 seconds, rotate the volume (set up) control to adjust the either the LEFT or RIGHT balance level. After about 5 seconds, the balance menu will switch off saving the balance settings in memory. A press longer than one second will toggle the tone option between TONE ACTIVE and TONE DEFEAT. Then within a few moments the tone controls will display. Then press the tone button to toggle through bass, treble and tilt functions. selecting TONE ACTIVE allows one to adjust the bass , treble , and spectral tilt settings of the M3 via the volume (set up) control. Bass and treble levels are adjustable between +/5dB. the spectral tilt adjustment allows for simultaneous +/-3dB bass and treble offsets. [. . . ] Press ON to turn on the REC/Z2 output; press OFF to turn off the REC/Z2 output. Once the REC/Z2 output is on, one can select the source inputs. nOTE: the REC/Z2 output is a fixed line level output. The volume control of the M3 does not control the level of this output. [. . . ]