User manual NAD VISO THIRTY

[. . . ] VISO TWENTY VISO THIRTY Owner's Manual IMPORTANT SAFETY INSTRUCTIONS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] to scroll down to "Speaker Settings". Press [ENTER] to ] button select "Speaker Settings" menu. At "Speaker Settings" OSD menu and with "Front" speaker item highlighted, set "Front" speaker to "Small" by pressing [< until ] button "Small". to select "Small" and at the same time ] button move on to the next item ­ "Center". Follow the same procedure ­ set "Center" to "Small" and also "Surround" to "Small". Speaker Settings Front Center Surround Subwoofer Enhanced Bass Do not Save & Exit Save & Exit Small Small Small On Off 5. With "Front", "Center" and "Surround" all set to "Small", press [?to ] button scroll down to "Save & Exit". Press [ENTER] to save the new settings and at the same time exit the Speaker Settings menu. Press [SETUP] button to completely exit the Setup menu OSD. Center Channel Level Setting as a default setting, we suggest adjusting the Center Channel level to -3dB. In Audio Setup menu select Channel Levels. on the ] button 9 remote to select Center speaker. Then by pressing the [< set the ] button level to -3dB. Channel Levels Front L Center Front R Surr L Surr R Subwoofer Do not Save & Exit Save & Exit 0dB -3dB 0dB 0dB 0dB 0dB 8. to scroll down to "Save & Exit. Press [ENTER] to save the new setting and at the same time exit the Channel Levels menu. Press [SETUP] button to completely exit the Setup menu OSD. Confirm the relative balance of your system's loudspeakers including the Center speaker by following the instructions in the section of the VISO FIVE DVD Receiver Owner's Manual entitled "USING THE VISO FIVE -AUDIO SETUP MENU". NAD VISO TWO If you're using an NAD VISO TWO DVD Receiver, you must configure the menu items "Listening Mode" and "Speaker Settings" to calibrate the frequency response of the system. The following steps will guide you in configuring your NAD VISO TWO receiver with respect to NAD VISO TWENTY speakers. Ensure that your NAD VISO TWO is unplugged when you connect the speakers. It is also advisable to power-down or unplug all associated components while making or breaking any signal or AC power connections. Connect at least one of the NAD VISO TWO Monitor Outputs (Component Video, S-Video or Composite Video Monitor Out) to a corresponding video input of a compatible TV/Monitor. [. . . ] Check the main fuse located in the power cord socket and replace as required. If the new fuse also blows, the subwoofer amplifier requires service. No sound/power indicator remains red The VISO S10 subwoofer utilizes signal sensing auto on/off circuitry. If no signal is sent to the subwoofer, it will not power up and the front panel power indicator will remain red. [. . . ]