User manual NADY CM-2S

[. . . ] CM-2S Stereo Condenser Microphone USER GUIDE Congratulations on purchasing the Nady CM-2S Stereo Condenser Microphone. This superior, versatile microphone provides the realistic spatial impact of a live sound field for many applications including stereo recording, ENG theater use, and FM stereo radio. [. . . ] Both Left and Right use a common Ground(-) connection on Pin 1. Use the 19" stereo cable to connect to 3. 5mm stereo inputs or the 10'cable to connect to two channels of your mixing console or recording equipment. Placing the mic closer to the sound source will create a more pronounced stereo image while moving the mic further away will lessen the stereo image and result in more room noise. Placing a mic too close to a multi-voice source may result is some voices being more dominant than others. Experiment with placement for the best possible results. Use the low-cut filter switch to reduce stage floor noise and undesired low frequencies. Before operating, install an alkaline or mercury AA battery by unscrewing, and sliding down, the lower portion of the handle to reveal the battery compartment. The CM-2S is only designed for battery use. DANGER: DO NOT USE PHANTOM POWER WITH THE CM-2S OR YOU COULD DAMAGE THE MICROPHONE. Note: Low bias voltages (such as those used for mini-disc, DAT, or analog recorders) will not harm the microphone. USING THE FOAM WINDSCREEN The foam windscreen, supplied with the CM-2S, fits over the grill portion of the microphone and is designed primarily to decrease bass rumble (from wind noise pickup) during outdoor live or recording use. [. . . ] (INTERNATIONAL) For service, please contact the Nady distributor in your country through the dealer from whom you purchased this product. Date of purchase _____________________________________________________________________________________________ Dealer's Name ______________________________________________________________________________________________ Street ______________________________________________________________________________________________________ City ____________________________________ State _____________________ Zip _____________________________________ Note: Do not attempt to service this unit yourself as it will void your warranty. SPECIFICATIONS ELEMENT: Fixed-charge back plate permanently polarized DYNAMIC RANGE (TYPICAL): 101dB, 1kHz at Max SPL condenser BATTERY TYPE: AA alkaline battery POLAR PATTERN: Cardioid (Unidirectional) stereo BATTERY LIFE: More than 1000 hrs FREQUENCY RANGE: 30 to 20, 000Hz SWITCH: Off, flat response, low-roll-off LOW-FREQUENCY ROLL-OFF: 150Hz, 6dB/octave SIZE: Diameter: 0. 83" (21. 0mm), Length: 7. 76" (197. 0mm), SENSITIVITY: -45dB (5. 6 mV) re 1V at 1 Pa Width: 2. 44" (62. 0mm), IMPEDANCE: < 250 Ohms unbalanced NET WEIGHT: 5. 8 oz (165 g) CHANNEL BALANCE: < 2. 5dB MAX. SPL (1% THD @1000HZ): 128dB S/N RATIO re 1Pa: 70dB Specifications and design subject to change for improvement purposes without prior notice. 03/09/04 [. . . ]