User manual NAIM ARMAGEDDON

[. . . ] Windows Media is a trademark of Microsoft Corporation. 5 and describes the operation of NaimUniti units running software release version 3. 6. xx. NaimUniti units running earlier software will not operate fully in the manner described in this manual. The software running in a NaimUniti is displayed in the Factory Settings menu. [. . . ] Select Large when no subwoofer is used (the NaimUniti subwoofer output is switched off when Large is selected). Select Small+Sub when a subwoofer is used to provide the low frequency component of a speaker system incorporating small (restricted bandwidth) satellite speakers. When Small+Sub is specified, a 100Hz high-pass filter is applied to the NaimUniti speaker output signal. Volume and Balance parameters specify maximum allowed volume, and the channel balance respectively. Note: If NaimUniti is connected to the network both wirelessly and via Ethernet (wired), the Ethernet connection will take priority. 4. 6. 1 Wireless Network Connection Set Up Select Network <Don't Use Wireless> LingNet 4GreenNet TomNet 3/6 4. 5 The Headpho ne s M e nu The Headphones setup menu enables the Max. Volume parameter to be specified: Parameter Max. Volume: Options 0 to 100 (adjust using handset 6 or 5 keys) Headphones 4Max. Volume: 1/1 100 If the Wireless parameter is selected in the Network Settings menu the Select Network menu will display a list of the available networks. An option not to use a wireless connection is also provided. Use the handset up (5) or down (6) keys to scroll through the list and the ok/list key to select a network. Note: Devices installed on a network have an IP address through which they are identified by all the other items on the network. DHCP is a set of rules that enable the automatic allocation of addresses as items are connected (or switched on while connected) to the network. NaimUniti is set up by default to use DHCP. 12 Press OK to confirm flatfish| Connected Press OK To Finish Can't Login Press OK To Re-Try Note: As a security measure, a router may also require the NaimUniti's MAC address to be entered before allowing it to join the wireless network. This type of security feature is known as `MAC address filtering'. The NaimUniti MAC address is shown in the `Factory settings > System Status' page. N a im U nit i Setu p Note: The wireless passphrase/access key is created when the wireless router is first set up and could be a word or a series of numbers and letters. If the passphrase/access key is not known, check on the router settings page or with the person who initially set up the router. Note: If a router offers multiple security configurations, NaimUniti will automatically offer only the most secure one. Note: If WEP security is used the router should be set to "auto" or "open" authentication. If the selected network is insecure and requires no passphrase or access key to join, NaimUniti will display an alert message. Pressing the handset ok/list key will immediately connect NaimUniti to the network and display a confirmation screen. This wireless network is insecure and requires no passphrase or access key. Press OK To Connect Parameter Off During Mute: Auto Off: Clock When Off: Logo Off: Options Yes / No Select time from list Yes / No If Muted / If Display Off / Always / Never When Off During Mute is selected the front panel display will switch off when mute is engaged. [. . . ] Alternatively, selecting a category using the up (5), down (6) keys followed by the ok/list key will display the full list of tracks contained within the category. Tracks can then be selected for playback by using the up (5), down (6) and ok/list keys. In long lists the handset numeric/text keys can be used to jump through the list alphabetically. Once playback is underway the NaimUniti display will exit from list mode and revert to normal mode where the handset transport keys ( ) can be used to control playback. [. . . ]