User manual NAIM FLASH REMOTE HANDSET

[. . . ] PRE-R - Numeric keys control preamp record selection. CD key (CD) Selects 1 of 3 CD pages. Numeric keys control CD track selection. TUN key (TUN) Selects Tuner page. Numeric keys control tuner preset or direct frequency selection. AV mode AV mode is used to control audio video products such as AV processors, DVD players and subwoofers. Volume down (6), mute (mute) and volume up (5) hotkeys control AV processor volume in this mode. 3 AV key (AV) Press and release to selects one of 3 AV pages. [. . . ] Lights The lights setting controls the screen and button backlight. It has 4 settings: off ­ always off. on ­ on whenever the handset is awake. auto ­ on whenever the handset is awake AND the ambient light level is low (default). energy ­ As auto unless battery low, in which case as off. Contrast The contrast setting adjusts the screen contrast. av-rc5 The AV-rc5 setting selects which AV code set to use from 0-9 (0 default). As the code set is changed a code set change command is transmitted to the AV processor to synchronize the handset and the processor. WARNING This setting should only be adjusted in conjunction with the appropriate AV processor system code setup procedure outlined separatelty. dvd-rc5 The dvd-rc5 setting selects which DVD code set to use from 15 (1 default). As the code set is changed a code set change command is transmitted to the DVD player to synchronize the handset and the player. WARNING This setting should only be adjusted in conjunction with the appropriate DVD player system code setup procedure outlined separatelty. 5 Softkeys The softkey setup menu allows alternate commands to be assigned to any of the 8 softkeys on each of the 13 predefined product pages. To assign a softkey, select the required product page using the OK (OK) key (press EXIT (EXIT) at any time to return to the instructions page). Then press the required softkey, indicated by a permanent underline. The UP (5)/ DOWN (6) keys can then be used to select any one of the available commands (see appendix 2). Each command has a product ID to indicate which product the command controls according to the following key: p-preamp, r-record, c-cd, t-tuner, a-av, d-dvd, s-sub. If a command for a product other than the selected page product is chosen, the product ID will be displayed in the main display. Appendix 3 contains default product and user preference tables. Reset Resets remote handset to factory defaults settings. [. . . ] Attach an anti-static earth strap to your wrist and connect the crocodile clip to the top negative battery terminal (connected to the black wire). You will notice two recesses on opposite corners of the PIC Socket. Place the small barbed end of the PIC extraction tool into one of the recesses in the corner of the PIC Socket. Lever the PIC partially out of its socket. [. . . ]