User manual NAIM NAIT2

[. . . ] The band always marks the end that connects to the signal source. Loudspeaker leads are also very important. Naim loudspeaker cable is correct for your system and your dealer will make up leads to suit your equipment installation. The leads should each be at least 3. 5 metres long and of equal length. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and the receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult your Naim dealer or an experienced radio/TV technician for help. 4 Nait 5 Integrated Amplifier inputs The Nait 5 has 6 inputs - CD, Tuner, Tape, A/V, AUX1 and AUX 2. Tape, A/V and AUX 1 all have record output facilities for your cassette deck, VCR etc. The AUX 2 input is provided with two sockets. Use the right hand socket (when viewed from the rear) for commenting your usual ancillary equipment. The extra (left hand) socket is for use with separate phono stage, such as the Prefix or Stageline. Only one of these sockets may be used at a time, for safety as well as performance. Your amplifier will have a protective cover fitted over the extra socket. If you wish to use this socket it is advisable to refit the protective cover over the unused socket to prevent mistakes. tape facilities and monitor button The tape monitor (mon) button allows you to listen to the output of a 3-head tape machine while recording to check the "off-tape" signal. preamp vol (up and down): Adjusts the amplifier output volume and the volume control position. mute: Reduces the amplifier output volume to zero. The mute button on the amplifier will illuminate when mute is selected. bal (left and right): Adjusts the output channel balance. Some Naim amplifiers have control of balance available only from the remote handset. On these products the balance will automatically "centre" as it reaches the mid point. Balance centring is indicated by a flashing volume control indicator. To resume adjustment once the balance has centred, bal key must be released and re-pressed. mon: The mon button enables the output of a 3-head tape machine to be heard while recording in order to check the "off-tape" signal. The source to be recorded is chosen by the input selector buttons in the normal way. After pressing mon, select the input to which your machine is connected. [. . . ] In cd mode the prog key enables specific CD tracks and their play order to be selected. To select a play order select a track number from the numeric keypad followed by the prog key until the desired selection is complete. During selection, the track number indicated in the player display will be followed by either "P", "-" or a space. "P" indicates that the track is already selected. [. . . ]