User manual NAIM NAT05 XS ISSUE 1

[. . . ] In order to comply with current European safety regulations it is essential that the Naim loudspeaker connectors supplied with amplifiers and loudspeakers are used. Do not under any circumstances allow anyone to modify your Naim equipment without first checking with the factory, your retailer, or your distributor. unauthorised modifications will invalidate your guarantee. Equipment must not be exposed to dripping or splashing and no objects filled with liquid, such as vases, should be placed on the equipment. [. . . ] Please contact your local distributor, or Naim directly, if any difficulties cannot be resolved. Some Naim equipment is made in special versions for different territories and this makes it impracticable to arrange international guarantees. Source components and power supplies should be switched on before the power amplifiers. Always switch amplifiers off and wait a minute before connecting or disconnecting any leads. Always use the power switch on the product rather than a mains outlet switch. A "thump" may be heard from the loudspeakers as power amplifiers are switched on. This is normal, will not cause any loudspeaker damage and does not point to any fault or problem. A mild "pop" may also be heard shortly after equipment is switched off. It is essential that repairs and updates are only carried out by an authorised Naim retailer or at the Naim factory. Many components are custom made, tested or matched and appropriate replacements are often unobtainable from other sources. Direct contact to Naim for service or update information should be made initially through Customer Services: Tel: Email: +44 (0)1722 426600 info@naimaudio. Naim equipment takes a considerable time to run in before it performs at its best. The duration varies, but under some conditions the sound may continue to improve for over a month. Better and more consistent performance will be achieved if the system is left switched on for long periods. It is worth remembering however that equipment left connected to the mains can be damaged by lightning. Please quote the product serial number (found on its rear panel) in all correspondence. In some circumstances, depending on where you live and the earthing arrangements in your home, you may experience radio frequency interference. Controls on broadcasting in some territories allow very high levels of radio frequency radiation and both the choice and exact siting of equipment may be critical. Susceptibility to radio frequency interference is related to the wide internal bandwidth necessary for high sound quality. Do not stand it directly on top of another item of equipment. It should be installed in its final location before connecting cables or switching on. ensure also that the system volume is turned down before switching on. [. . . ] In scan mode, the down button or left (3) key causes the tuner to "scan" down the FM band searching for signals above a preset level. The tuner will stop at each tuned station and, using the remote handset, the option to store the station as a preset will be available (see Section 6. If no satisfactory signals are found during the first scan, a second scan at a lower preset signal level will automatically commence. In preset mode, the down button or left (3) key causes the tuner to step sequentially down through previously stored stations. [. . . ]