User manual NAPCO RP1054D KEYPAD

[. . . ] OPERATING GUIDE FOR YOUR RP1054D KEYPAD © Napco 1992 DESIGN PATS. PENDING INTRODUCTION CONGRATULATIONS!. . . on your purchase of a NAPCO Magnum Alert security system. Your new installation is a sophisticated warning system with many available features. [. . . ] Steady Tone (when entering) ­ entry delay in progress. Beep (of programmed duration) ­ Chime Zone tripped. Beep (2 seconds) ­ system armed with a zone in trouble. Pulsing ­ Day Zone trouble; Fire Zone in trouble or in alarm. (To stop sounder "Trouble" warnings, hold down Key [9] for 2 seconds. ) BYPASS BUTTON (Key [S]) To manually bypass a zone, press this button, then the digit representing the zone number. Refer to SETTING THE ALARM WHEN LEAVING: Arming With A Zone In Trouble. PANIC BUTTONS (KEYS [ * ] & [# ], Optional) Pressing these keys simultaneously will activate a Panic Alarm. See PROTECTING YOURSELF WHILE ON THE PREMISES. HOLD-DOWN FUNCTIONS To perform designated "Hold-Down" Functions, selected key must be held down for about 2 seconds, until sounder beeps. Note: Those functions identified by an asterisk (* ) have secondary utility functions for installer's use only. Do not attempt to access these functions within 10 seconds after disarming. Key [1]: TEST Momentarily sounds the burglar alarm. If no alarm is heard, or if it is weak, the battery may need replacing. (To perform this function, hold down Key [1] until alarm sounds. ) Key [2]: DISPLAY BYPASS Numerically displays all zones that have been bypassed using Key [S]. To perform this function, hold down Key [2] until the sounder beeps, and continue to hold it down until all zones have been displayed. Key [3]: DISPLAY STATUS Numerically displays all zones that are in "trouble". To perform this function, hold down Key [3] until the sounder beeps, and continue to hold it down until all zones have been displayed. Key [4]: INSTANT PROTECTION* Cancels entry delay period when arming. The delay is restored after you disarm the system. To perform this function, hold down Key [4] until the sounder beeps. Key [5]: CHIME* (Chime Zone(s): _________) This will enable a feature that sounds a "chime" (beep) at the keypad each time a programmed zone (Entry Zone, in the MA854) is opened. The Chime Mode functions when the alarm system is disarmed (off), but it will always operate on a Never-Arm Zone (see GLOSSARY). To disable the chime feature, hold down Key [5] again (until sounder beeps). [. . . ] Enter your code to arm remaining zones; the green light will go off and the red ARMED/ALARM light will come on. The yellow light will go off the next time you disarm, indicating that the bypassed zones are no longer bypassed. (The BYPASS light does not come on when zones are auto-bypassed (unless programmed otherwise by your alarm specialist. ) To review which zones have been bypassed, hold down Key [2] until all bypassed zones have been displayed. Arming With Instant Protection Holding down Key [4] (until beep sounds) will cancel the entry delay on the exit/entry zones when arming. [. . . ]