User manual NAPOLEON GRILLS FREESTYLE SS MOUNTING BRACKETS

[. . . ] GOURMET GRILLS LE GRILS DU GOURMET MANUFACTURED BY / MANUFACTURE PAR: NAPOLEON APPLIANCE CORP. , 214 BAYVIEW DR. , BARRIE, ONTARIO, CANADA L4N 4Y8 CUSTOMER SERVICE PHONE: (866) 820-8686 FAX: (705)727-4282 EMAIL: ask@nac. on. ca WEBB SITE: www. napoleongrills. com PTSS215 ACCESSORY MOUNTING INSTRUCTIONS Please use this manual in conjuction with your main manual to properly assemble your gas grill. Refer to the main manual for operating, cleaning, and maintenance instructions. WARNING: - This grill is not to be used while the vessel is in motion. - When operating the grill on a vessel, only 8 oz cylinders that are DOT approved (2P/2Q) can be used in the United States. These cylinders are available at your local marina or hardware store. [. . . ] Remove all the parts from the packaging. Attach the post to the casting using four 1/4-20 x 1" hex head bolts. Ensure that the holes on the back side of the post face the same direction as the groove on the bottom back of the foot casting. Place the spacers provided on the three nutserts that are closest to the front of the post. Place the platform with the latch to the front onto the three spacers. Attach with the three 1/4-20 x 1 3/4" flat head bolts. Attach the back post cover with the two #8 screws provided. Once the post is completely assembled, the grill can be mounted: a. Lock the lid of the grill closed with the latch. Hold the grill by the handle with one hand, place the other hand under the grill in the centre of the front tapered surface. Place the grill bottom on the platform and slide it forward to engage the tab protruding from the bottom of the grill. Ensure that the tab is properly engaged. When the dimples on the bottom of the unit line up with the holes on the platform, the latch is ready to be fastened. Once the grill has been attached, thread the regulator (clockwise) into the regulator mount. On tube burner version, lift the burner slightly to align it with the orifice. To fasten the regulator locking bracket, locate it at the bottom back corner of the regulator mount and turn the regulator until the gas inlet is aligned with the hole in the regulator locking bracket. Slide the locking bracket forward until the two tabs engage into the slots on the regulator mount. Attach the cylinder to the regulator by turning clockwise. (Be sure not to cross thread the cylinder. ) 3 INSTRUCTIONS POUR LES ENSEMBLES DE SUPPORT AVERTISSEMENT : - Ce gril ne doit pas être utilisé lorsque le bateau est en mouvement. - Lorsque vous utilisez le gril sur un bateau, seules des bonbonnes de 8 oz certifiées DOT (2P/2Q) peuvent être utilisées aux ÉtatsUnis. Au Canada, des bonbonnes de 16 oz peuvent être utilisées. Ces bonbonnes sont disponibles à votre marina locale ou dans une quincaillerie. [. . . ] Glissez le support vers l'avant jusqu'à ce que les deux pattes s'engagent dans les fentes sur le boîtier du régulateur. Donnez un coup sec pour bien engager les pattes. Fixez la bonbonne au régulateur en vissant vers la droite. (Assurez-vous de ne pas fausser le filetage de la bonbonne. ) 5 Instructions pour le support sur poteau : 1. [. . . ]