User manual NAVMAN CLUBWIND 3150

[. . . ] WIND 3150 Installation and Operation Manual English . . . . . . . . . . . . . c o m NAVMAN WIND 3150 Installation and Operation Manual NAVMAN 1 FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The WIND 3150 output is switched to ground, 30 V DC and 250 mA maximum. If the beepers and lights require more than 250 mA, fit a relay. For systems of several instruments, wiring and connectors are required (see the NavBus Installation and Operation Manual). In order to display true wind speed and angle and VMG, the WIND 3150 must be connected to an instrument that outputs boat speed (see section 9). The WIND 3150 is usually used with the supplied masthead unit. However, the unit can take readings from another NAVMAN wind instrument, in which case the masthead unit does not need to be fitted to this WIND 3150 (see section 9-1). 10-3 Accessories These accessories and spare parts are available from your NAVMAN dealer. Replacement masthead unit Replacement wind cups Replacement vane NavBus junction box (see section 9-1) NAVMAN WIND 3150 Installation and Operation Manual 11 11 Installation and setup Correct installation is critical to the performance of the unit. It is vital to read this section of the manual and the documentation that comes with the other parts before starting installation. The WIND 3150 can: Drive external beepers or lights for the alarm. Send and receive data from other NAVMAN instruments connected via NavBus. Settings for alarms, units, calibration and backlighting are shared (see section 9-1). Send and receive NMEA data to and from other instruments (see section 9-2). Side view of display unit mounting: 20 mm (0. 75") maximum panel thickness Fixing nut Fixing hole 50 mm (2") Warnings The unit is waterproof from the front. Protect the rear of the unit from water, or else water might enter the breathing hole and damage the unit. The warranty does not cover damage caused by moisture or water entering the back of the unit. The cable up the mast to the masthead unit must run in conduit. Ensure that any holes that you cut will not weaken the boat or the mast. If in doubt, consult a qualified boat builder or marine engineer. Display unit Cables Clearance 50 mm (2") minimum Masthead unit Plan the installation. Read through these instructions before you install the masthead unit and plan where you will fit the mounting block and where you will drill the cable holes in the mast. It is usually easiest to install the masthead unit when the rig is off the boat. 1 The mounting block is at one end of the 30 m (98 ft) masthead cable. Fit the mounting block on top of the mast: With the base of the block horizontal. With the fitting for the masthead arm facing forward, parallel to the centre line to within a few degrees (if the arm does not face exactly forward, the wind angle must be calibrated, see section 8-1). [. . . ] Ph: +64 9 481 0500 e-mail: marine. sales@navman. com Website: www. navman. com 55 ASIA China Peaceful Marine Electronics Co. Hong Kong, Guangzhou, Shanghai, Qindao, Dalian. E210, Huang Hua Gang Ke Mao Street, 81 Xian Lie Zhong Road, 510070 Guangzhou, China. Ph: +86 20 3869 8784 e-mail: sales@peaceful-marine. com Website: www. peaceful-marine. com Korea Kumhomarine Technology Co. , Ltd. [. . . ]