User manual NAVMAN DEPTH 2100

[. . . ] DEPTH 2100 Installation and Operation Manual English . . . . . . . . . . . . . c o m NAVMAN FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To exit this mode, press and hold both simultaneously. tdr Units of Measure To select the displayed unit 1. Apply power while holding down . V OFF Hold down during power up 5 2. The display will indicate the current display unit with: 3. Use and to change the value. 8Ft 888 8FA Feet Metres Fathoms and 4. To exit this mode, press and hold both simultaneously. Alternatively, if no keys are pressed for a period of 5 seconds normal depth display will resume. ON ^ V OFF Press simultaneously The display will now indicate the current water depth in the selected display unit. 3 Dual Station Operation Multiple Depth 2100 instruments can be installed on a single vessel. These instruments can be connected together and configured to operate in a dual station configuration. One instrument is designated as a master and all other instruments, connected to it, are configured as slaves. The master device is connected to the depth transducer and determines the water depth. This information is then displayed on all slave devices connected to it. Slave devices do not have transducers connected to them. The slave devices can be configured to operate as fully functional NMEA repeaters where they display water depth, as displayed on the master device, and share common alarm settings and keel offset values. In this mode the common alarm settings can be changed or activated/deactivated from either the master or slave devices. Alternatively, the slaves can be configured to operate as independent slaves. In this mode the slaves display the water depth received from the master, but have independent alarm settings and keel offset values. Note: The instrument designated as the master device is the only instrument connected to the depth transducer. Use Master/Slave Selection To select the master/slave mode of operation: 1. Apply power while holding down . V OFF Hold down during power up 2. The display will first indicate the current display unit: 8Ft Example 4 Maintenance Your depth sounder is designed for years of trouble free operation assuming proper installation and care are provided. Following the operation and installation guidelines in this manual should ensure optimum performance of the instrument. In the unlikely event that the instrument shall fail to perform or shall need servicing, contact the dealer whom you purchased your Depth 2100 from. NAVMAN DEPTH 2100 Installation and Operation Manual 7 5 Installation Instrument Installation 2. 5" 63. 5 mm The instrument can be easily installed in different types of instrument panels. Select a suitable location for the instrument. [. . . ] Ph: +64 9 481 0500 e-mail: marine. sales@navman. com Website: www. navman. com ASIA China Peaceful Marine Electronics Co. Hong Kong, Guangzhou, Shanghai, Qindao, Dalian. E210, Huang Hua Gang Ke Mao Street, 81 Xian Lie Zhong Road, 510070 Guangzhou, China. Ph: +86 20 3869 8784 e-mail: sales@peaceful-marine. com Website: www. peaceful-marine. com India Access India Overseas Pvt A-98, Sector 21, Noida, India Ph: +91 120 244 2697 Email: vkapil@del3. vsnl. net. in Indonesia Polytech Nusantara Graha Paramita 2nd Floor Jln Denpasar Raya Blok D2 Kav 8 Kuningan, Jakarta 12940 Tel: 021 252 3249 Korea Kumhomarine Technology Co. , Ltd. [. . . ]