User manual NAVMAN GPS4100

[. . . ] English Edition Bluetooth GPS Receiver TM 4100 / 4420 / 4470 User Manual Bluetooth GPS Receiver | User Manual Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Bluetooth GPS Receiver Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Connecting the Bluetooth GPS Receiver to your PDA . . . . . . . . . . . . . . . [. . . ] · Avoid locations subjected to excessive shock or vibration. · The receiver must be within 10 m (33 ft) of your PDA. · The receiver is not waterproof -- mount it where it will not get wet (including condensation). Note: If your vehicle is fitted with an athermic (heat reflecting) or a heated windscreen, you may need to purchase a Navman external antenna to allow your Bluetooth GPS Receiver to receive GPS signals inside the vehicle. The Bluetooth GPS Receiver and your PDA are mounted separately in your vehicle. Follow these instructions carefully to ensure proper installation. For security purposes and to avoid overheating, do not leave the Bluetooth GPS Receiver or your PDA on the dash or attached to the windscreen while your vehicle is unattended, especially in strong sunlight. Positioning your Receiver Option One: Windscreen Suction Mount You can position the Bluetooth GPS Receiver on the inside of your vehicle windscreen or back window using the receiver windscreen suction mount and receiver cradle: 1. Insert the tab on the receiver windscreen suction mount into the receiver cradle slot. Tab Slot 2. Fasten the receiver cradle to the receiver windscreen suction mount by using the two screws provided. Find a suitable position in your vehicle for the Bluetooth GPS Receiver to be mounted. Use the alcohol swab to thoroughly clean the window area that the suction cup will be mounted to. Do not touch the area after it is cleaned. Do not touch the bare suction cup surface. Press the suction cup firmly to the window, then pull the lever down and away from the window. Slide the Bluetooth GPS Receiver into the receiver cradle. To remove the receiver windscreen suction mount from the windscreen or back window, press the lever down and toward the window and gently lift the tab on the rim of the suction cup. Tab Lever 7 Bluetooth GPS Receiver | User Manual Option Two: Mounting Pad on Dashboard (Permanent) You can attach the Bluetooth GPS Receiver to the dashboard using the receiver cradle and mounting pad: Warning: This is a permanent solution ­ the mounting pad cannot be removed once fixed and will mark the dashboard if forcibly removed. Remove one of the backing layers from the receiver mounting pad. Attach the sticky side of the mounting pad to the under-side of the receiver cradle. Find a suitable position in your vehicle for the Bluetooth GPS Receiver to be mounted. Use the alcohol swab to thoroughly clean the area of the dashboard that the cradle will be mounted to. Do not touch the area after it is cleaned. Remove the second backing layer from the mounting pad. [. . . ] The replacement product or component takes on the warranty status of the original product or component. This is Your exclusive remedy for defective products. Limitations: This warranty does not apply to products that have been damaged or rendered defective: (a) as a result of incorrect installation, misuse, mishandling, misapplication, accident, abuse, breakage or other external causes; (b) by operation outside the usage specifications stated in the product documentation; (c) by modification or service other than by Navman or its approved Service Centres. Limitation of Liability: To the fullest extent permitted by law, Navman will not be liable in any event, whether in tort (including negligence), contract or otherwise for any damage including loss of profits, any consequential, indirect or special damage, loss or injury of any kind suffered by You or any other person. [. . . ]