User manual NAVMAN ICN600 SMART ST2005

[. . . ] (*) only provided with the iCN 630 product. Before you can begin using your iCN, the smartMAPTM application and maps must be installed onto your iCN. These can be found on the CD-ROMs supplied with your iCN. Complete the following tasks: IMPORTANT: Steps 1 to 5 must be performed in this order to ensure a successful installation. [. . . ] Once the installation is complete, click on "Activate Software" to register your installation on-line. The iCN can be mounted in three different ways: By suction straight onto the windshield By suction or an adhesive disc onto the dash; By directly screwing onto the dash (iCN 630 only). For detailed information on using options 2 and 3, refer to the User Manual, Installing the iCN into your Vehicle. Follow the safety guidelines to ensure that the iCN does not obstruct the view of the driver, or interfere with the operation of any airbags and safety devices in the vehicle. Choose a position on the windshield where the iCN will be clearly visible by the driver without obstructing the view of the road. Thoroughly clean and dry the suction cup and the windshield. Hold the suction cup firmly against the windshield and press the lever down until it snaps close. The ball foot should now be securely fixed on the windshield. Slip the locking nut loosely over the ball foot, with the flat side facing upwards. First, position the two locating tabs on the underside of the iCN into the corresponding slots on the socket clip. Then snap the upper side of the iCN into the clip. The GPS antenna is pointing horizontally out, with a clear view of the sky. It may initially take several minutes to get a GPS fix. Minimise this time by remaining stationary in your vehicle until the iCN has a fix. To confirm you have a GPS fix select "Map" from the Main Menu. The map screen will show your current location, if you have a GPS fix. The GPS fix is displayed in the lower left corner of the screen. No GPS fix, the satellite icon is red and the strength indicators are not displayed. Setting a destination There are three main ways that you can program your destination: Use "SHORTCUTS" that you have previously programmed for destinations used on a regular basis. program your destination directly on the "MAP". Set a new "DESTINATION" by entering an address, intersection, Point of Interest, favourite or recently travelled location. refer to the User Manual for information on programming Shortcuts and Favourites. [. . . ] If you have already programmed a route, the route and all turns are highlighted. Navigation map Similar to the Map Browser view, except that the map is always oriented to the direction in which your vehicle is travelling. This is often an easier way to keep your bearings. Next instruction This view clearly shows the information that you need for the next turn the direction of the turn and the distance to the turn. [. . . ]