User manual NAVMAN SMARTCRAFT GATEWAYS

[. . . ] SmartCraft Gateways For single and dual engine applications Installation and Operation Manual www. navman. com NAVMAN ! CAUTION IMPORTANT SAFETY INFORMATION This is the safety alert symbol. It is used to alert you to potential personal injury hazards, Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. CAUTION used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. ! Please WARNING read carefully before installation and use. DANGER ! [. . . ] In speed troll control, the boat might not reach the desired speed if the maximum RPM available for troll control is too low or if conditions are bad. Troll can not engage unless engine throttle(s) are in idle, and engine(s) are in gear. Troll control is not available on some MerCrusierTM engines. To use speed troll control, the Navman instrument must have a Navman paddlewheel speed sensor connected. 2 3 Changing RPM or speed while troll control engaged 1 2 3 From a main display, press the troll window. to display or to change the desired RPM or Press boat speed (see notes 1 and 2). Press 2 Disengaging troll control Either move the throttle from idle, or: 1 From a main display, press or the troll window. Press (Disengage) and press Or, press engaged. to display to select Off 3 4 5 2 to leave troll control 4-4 Trim indicator When the optional engine trim is adjusted, a trim popup window can show the new trim angle. To see this window or not, set Trim popup to On or Off (see section 4-7: Trim). The window will automatically disappear after two seconds, or else press to close the window. Before use, calibrate trim (see section 4-7: Trim). NAVMAN SmartCraft Gateways Installation and Operation Manual 21 4-5 Engine fault alarms There are many SmartCraft engine fault alarms. These alarms operate just like the other alarms in the Navman instrument; when the alarm sounds, to mute the alarm: press Low reserve oil. A Navman instrument's low battery alarm measures the voltage at the instrument; the above two alarms measure the voltage at the engine. Low drive lube: (MerCrusier stern drive only). Engine GuardianTM active: The Engine Guardian has detected a fault. Engine communication lost: The Navman instrument can not receive engine data from the SmartCraft gateway. Check engine: There are many other engine fault alarms. When one of these alarms sounds, the alarm Check engine is displayed. For more information about the alarm, display the list of active alarms or the alarm history (see section 4-6). Notes: 1 2 For help when an SmartCraft alarm occurs, contact your Mercury dealer. The alarm values are determined by the engine type. A list of active faults and a fault history can be displayed (see section 4-6). 3 4-6 Engine fault lists There are two lists of SmartCraft engine faults: When the faults list is displayed Press list. [. . . ] Ph: +52 33 3283 1030 Fax: +52 33 3283 1034 web: www. equinautic. com. br Uruguay Alvaro Burmudez, Nautica Puerto del Buceo 11300 Montevideo, Uruguay. Phone & Fax +59 82 628 6562 e-mail : alvaro@nautica. com. uy web: www. nautica. com. uy ASIA China Peaceful Marine Electronics Co. Guangzhou, Hong Kong, Dalian, Qingdao, Shanghai 1701 Yanjiang Building 195 Yan Jiang Zhong Rd. Ph: +86 20 3869 8839 Fax: +86 20 3869 8780 e-mail: sales@peaceful-marine. com web: www. peaceful-marine. com India Access India Overseas Pvt. [. . . ]