User manual NAVMAN TRACKER 5430I

[. . . ] Pilot 3380 Tracker 5430/5430i AU C H A R T PT LO O P T I T L E O R T Installation and Operation Manual www. navman. com FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press MENU and select Edit on chart. 2 1 2 10-2-5 Deleting all routes 10-3 Navigating a route 10-3-1 Starting a route To start the boat navigating along a route: 1 In the routes display, press or to highlight the route to use. The TRACKER asks for the direction to traverse the route. Select Forward (the order the route was created) or Reverse. 3 It displays a chart with the route marked and starts navigating from the start of the route. 10-3-2 Skipping a waypoint in a route To skip a waypoint when the boat is navigating along a route: In the chart display, press MENU and select Skip. The TRACKER starts navigating straight towards the next waypoint on the route. Warning: Skipping a waypoint with the autopilot on might result in a sudden course change. 2 10-3-3 Cancelling a route To stop the boat navigating along a route: In the chart display, press MENU and select Cancel route. 24 NAVMAN TRACKER 5430/5430i Installation and Operation Manual 11 User card display A C-MAPTM user card is an optional plug-in card that can store data files (see section 1-2). There are three types of files: waypoints, routes or a track. Note: The older 5 volt cards are not supported. To go to the user card display, press DISP and select User card. The user card display has: File list A list of the files on any user card in the TRACKER. Waypts, Routes The number of waypoints and routes currently in the TRACKER. Track 1 to Track 5 The number of points in tracks 1 to 5 currently in the TRACKER. Note: To save TRACKER data onto the user card, use the Save command (see below). Data stored on the user card and shown on the file list is not available to be used by the TRACKER until loaded into the TRACKER with the LOAD command (see below). Skip: Do not load the new waypoint. Replace: Load the new waypoint and replace the existing one. Skip all: Do not load any new waypoints which have the same names as existing waypoints. all: Load all new waypoints which have the same names as existing waypoints; the new waypoints replace the existing waypoints. A routes file: The new routes are added to any existing routes in the TRACKER. If a new route has the same name as an existing route but has different data then the TRACKER asks which route to keep. A track file: The new track will replace the existing track in the TRACKER. To load a file to the TRACKER: 1 2 Select the file to load. Press MENU and select Load. Saving TRACKER data to the user card This saves all the TRACKER's waypoints, all the TRACKER's routes or one of the TRACKER's tracks to one file on the user card. [. . . ] Goto - A simple way of navigating straight to a waypoint or to the cursor position (see section 3-3). A satellitebased navigation tool (see section 7). Leg - The straight segments of a route between waypoints. A route with four waypoints has three legs. 42 NAVMAN TRACKER 5430/5430i Installation and Operation Manual Navigation data The boat is sailing from the start to the destination and has moved off the plotted course from the start to the destination. [. . . ]