User manual NEC DIRECTION SPL SERVICE MANUAL

[. . . ] PROPRIETARY NOTICE AND LIABILITY DISCLAIMER The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Computer Systems Division, Packard Bell NEC, Inc. (hereinafter "NEC CSD") and/or its licensors. NEC CSD and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use, and sales rights thereto, except to the extent said rights are expressly granted to others. The NEC CSD product(s) discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product. [. . . ] Lift the access cover off the system. REPLACING THE ACCESS COVER To replace the access cover, use the following procedure. 1. Gently set the access cover inside the edge of the case, taking care not to bend the metal tabs. 2. Align the tabs on the access cover with their corresponding slots on the system. Insert the tabs on the edge of the access cover into their slots on the system. Figure 3-2 Aligning the Tabs Option Installation 3-5 3. Slide the access cover forward to meet the front panel. Tighten the thumb screw. NOTE: The cover fits tightly. If it does not slide all the way to the front panel, place one hand on the front of the unit while you slide the cover forward from the rear. 5. Plug in power cables. EXPANSION BOARDS Your computer's system board features several expansion slots that can accommodate accessory adapter boards, such as a sound board or TV board. Depending on the system you purchased, some of these devices may be installed in your system. The Direction Series supports ISA Plug and Play expansion boards. Plug and Play allows the installation of a board in an expansion slot without changing the hardware settings. There are no system resource conflicts to resolve. Plug and Play automatically configures the board for the system. Industry-standard 8-bit and 16-bit ISA, and 32-bit PCI expansion boards are supported in the system unit. ISA expansion boards can be Plug and Play or non-Plug and Play boards. PCI expansion boards run at one half the system host's bus speed. The PCI bus handles 32 bits of data at a time, being wider as well as faster than the standard ISA bus. PCI boards can send and receive data much faster, thereby boosting system performance. Expansion Slot Locations Your system has six expansion slots: T one ISA slot T three PCI slots T one shared ISA/PCI slot T one AGP slot. The following figure shows expansion slot locations. 3-6 Option Installation Figure 3-3 Locating Expansion Slots Expansion Board Installation Install expansion boards in the system as follows. 1. Follow any preinstallation instructions that come with the expansion board (such as setting switches or jumpers on the board). 3. Remove the screw securing an expansion slot cover and remove the cover. Figure 3-4 Removing the Slot Cover Option Installation 3-7 Save the screw for installing the expansion board. Be sure to save the slot cover for future use. CAUTION: A slot cover can damage the system board or any option board if it falls into the system. Take care to keep the slot cover from falling when removing the screw. [. . . ] The Department does not guarantee the equipment will operate to the user's satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company's inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). [. . . ]