User manual NEC DSX WIRELESS HEADSET ADAPTER

[. . . ] Be sure to read and follow the information in that guide regarding: ­ Charging and positioning your headset. ­ Applicable warnings, safety, and regulatory information. ­ Wireless Headset System maintenance and troubleshooting. This device complies with Part 15 of the FCC Rules. [. . . ] Carefully snap the DSX Headset Adapter into the telephone base. 4 Connecting to the Headset System Connecting to the Headset System Base Connecting the Headset System 5 To connect your telephone to the Headset System Base: 1. At right, using the short line cord provided with your Headset System, plug the cord into the telephone's headset jack and the jack on the Headset System base. Then, plug the extension's line cord into the jack on the bottom of the telephone. 3. Above, insert the Headset Adapter plug into the lifter jack on the Headset System base. At right, plug the Headset System power supply into the base and into a handy 110 VAC outlet. Setting up the Headset System Controls The Phone System Configuration Dial To set the Configuration Dial for DSX compatibility: 1. At left, turn to position 1. Intellistand Enable/Disable TM Configuration Dial Note: When charging your headset with Intellistand enabled, firmly seat the headset in the base. TM IntellistandTM Enable/Disable Even though you are not using a Handset Lifter, you should enable IntellistandTM. Above, set to the bottom position. Call Control Buttons The Call Control Buttons Use these buttons to answer a ringing call or hang up your current call. Not all base units have a Call Control button. ­ See your Plantronics User Guide for more. 6 Adjusting the Speaking Volume To adjust the headset speaking volume: 1. Set the Transmit Slide Switch to position C. While on a call, adjust the Headset Microphone Volume Control as required. Transmit Volume Control Transmit Slide Switch Receive Volume Control and Mute Adjusting the Listening Volume To adjust the headset listening volume: 1. Set the Receive Slide Switch to position 2. While on a call, adjust the Headset Receive Volume Control as required. ­ The volume control on your headset may be different than shown. Press and release the Headset Receive Volume Control to mute; Press and release to un-mute. Receive Slide Switch Setting the Controls 7 Using the Headset Your extension is automatically in the Headset Mode when your headset is removed from its base. There is no need to have a Headset Feature Key or dial #HS to turn the Headset Mode on and off. To place a call when using your headset: 1. Press a line key or INTERCOM and dial normally. [. . . ] Tap Call Control. Other Feature Interactions ­ Pressing MUTE while on a call mutes the headset microphone. ­ Off-Hook Signaling works normally. ­ Paging announcements broadcast through the telephone speaker, not the headset. [. . . ]