User manual NEC DTR-1R-2

[. . . ] D term ® Analog Cordless II (DTR-1R-2) User's Manual TABLE OF CONTENTS Welcome/Features/Terminology . . . . . . . . . 1 WELCOME . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 TERMINOLOGY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If you pass the range limits of the base unit, you will hear a beep and see Ou t o f Ra ng e on the display, and then the handset returns to standby mode. Privacy Mode Privacy Mode prevents interruption from other registered handsets. This works only when the phone is in use. Press the PRIVACY soft key on the handset during talk mode. Priv acy Mode On and appear in the display. To exit the Privacy Mode, press the PRIVACY soft key again when the Privacy Mode is on. Pr i va cy M od e O ff appears. Basics [ 17 ] THIS PAGE INTENTIONALLY LEFT BLANK [ 18 ] Basics Phonebook Phonebook (Storing Phone Numbers, Names, Distinctive Rings and Speed Dial) You can store names and numbers in your phone's phonebook, search for names alphabetically, and dial phonebook entries with just a few key presses. You can store up to 100 numbers in the handset. The phone uses the same memory locations to store phonebook entries and Caller ID messages. Any empty phonebook locations are used to store Caller ID messages. For example, if you have stored 100 phonebook entries on your handset, the handset will not store Caller ID messages. 1 When the phone is in standby mode, press phonebook. The following items appear: (1st line) The number of the phonebook locations used (2nd line) How to search (press the number keypad, (3rd line) How to store (press the STORE soft key) (4th line) The BACK, COPY, and STORE soft keys. 2 3 Press the STORE soft key, S to re /E d it N am e appears. Enter the name (up to 16 characters) by using the number keypad (see the "Steps for Entering Names and Special Characters"). If a name is not required, go to step 4. <No Name> will be used as the name. 4 5 Press the OK soft key to store the name; S t or e/ Ed it No . Use the number keypad, */tone/<, or #/> to enter the phone number (up to 20 digits). If you make an error, use the DELETE soft key to erase the incorrect digits. When you are finished, press the OK soft key to store the number. Press /vol/ or /vol/ to move the pointer to one of the Distinctive Ring options and then press the OK soft key. Press /vol/ or /vol/ to move the pointer to select the Speed dial location (10 locations: SPD1-SPD0). P H O N E BO O K /vol/ or /vol/) 6 7 Additional Information [ 19 ] 8 Press the OK soft key. You will hear a confirmation tone, and Do ne ! [. . . ] Phone cords are fitted with a molded plastic connector which plugs into this type of jack. If you do not have modular phone jacks, contact your local telephone company for information about their installation. Hardwired Jack Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your authorized NEC telephone representative or a telephone supply store for advice about the proper adapter or converter for your particular situation. Cordless Telephone Privacy Cordless telephones are radio devices. [. . . ]