User manual NEC GT6000

[. . . ] GT6000/GT5000 LCD Projector User's Manual Important Information Precautions Please read this manual carefully before using your NEC GT6000/ GT5000 Projector and keep the manual handy for future reference. Your serial number is located on the bottom of your GT6000/ GT5000. Record it here: If you are a user of the GT6000R, read the supplied document which describes the differences from the GT6000. CAUTION To turn off main power, be sure to remove the plug from power outlet. [. . . ] (DIU 2. 0) Check Points Are the personal computer and the projector connected by a serial cable?Or, are the personal computer and the projector connected by a LAN?When the personal computer and the projector are connected with a LAN, is the projector in the idle mode?Countermeasures Connect the personal computer and the projector with an serial cable or USB cable. Or, check the LAN port (RJ-45) of the projector. Purchase the optional wireless LAN card for wireless LAN connection. In the [Projector Options] [Setup] menu of the projector, place checkmark in "Idle Mode". Connect a power cable to the power outlet and set the main power switch to "I (On)". <Problem> You want to delete the PowerPoint add-in registration. (PPTC 2. 0) Check Points Installing this projector software when Microsoft PowerPoint 2000/2002 has already been installed on the personal computer, will result in the automatic registration of the add-in to PowerPoint. Countermeasures Please see the PowerPoint Help function for the method of deleting PowerPoint add-in registrations. The PowerPoint add-in registration will not be deleted even when this projector software is uninstalled. 6-8 6. Using the Projector in a Network <Problem> Projection to the screen is not possible when using the LAN environment. (DIU 2. 0, IEU 1. 0) Check Points Have LAN cards (i. e. , adapters) been put into both the personal computer and the projector?Have the LAN settings (for both the personal computer and the projector) been completed?Are a wired LAN and a wireless LAN being used simultaneously with the same personal computer?Countermeasures Put LAN cards (i. e. , adapters) into both the personal computer and the projector. Perform the LAN settings for both the personal computer and the projector. Please cancel either one of the LAN connections. When a builtin type is used, set it to "not used" under Properties. Image Express Utility 1. 0 does not support the following: (1) Software using Direct X (2) MS-DOS screens (3) Microsoft Office assistant (4) IME (5) When starting a moving video application first or using some computer's environments, sending a moving video image may not be possible. On the LT260K and LT240K, images cannot be sent from the "Dynamic Image Utility 2. 0" on a PC to the projector on the Continuous Transmit of the Image Express Utility 1. 0. Quit the Continuous Transmmit in the Image Express Utility 1. 0 and then send the image from Dynamic Image Utility 2. 0. <Problem> Operation of this projector software becomes unstable. (DIU 2. 0, IEU 1. 0) Check Points When the network settings of the projector or personal computer are changed while this projector software (i. e. , Dynamic Image Utility 2. 0 or Image Express Utility 1. 0) is starting or running, the operation of the projector software may become unstable. [. . . ] Accident, misuse, abuse, neglect, improper ventilation, fire, dust, smoke, water, lightning or other acts of nature, unauthorized product modification, or failure to follow instructions supplied with the product. Repair or attempted repair by anyone other than a NEC Solutions authorized service center. Any shipment of the product (claims must be presented to the carrier). Any other cause which does not relate to a product defect. [. . . ]