User manual NEC LCD205WXM

[. . . ] All required information concerning the disposal of the product and country-specific information on recycling facilities can be found on our following websites: http://www. This monitor features an advanced energy saving capability. 48W (LCD225WXM) Less than 2W Less than 1W LED color Green Orange Unlit Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical and electronic products carrying the mark (left) must be disposed of separately from normal household waste. This includes monitors and electrical accessories, such as signal cables or power cords. [. . . ] For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A. Connect one end of the power cord to the monitor and the other end to the power outlet. Position the Video Signal Cable, Audio cable and power cord between the holes on the Stand. To attach the Cable management cover, insert the tabs of the Cable management cover into the holes on the Stand and slide the Cable management cover downward into place (Figure B. 1) making sure that the tabs are completely secure. NOTE: Adjust the position of the cables that are placed under the Cable management cover to avoid damaging the cable or monitor. Please refer to the Caution section of this manual for proper selection of power cord. Turn on the monitor with the front power button and the computer (Figure C. For further adjustments, use the following OSD controls: · Refer to the Controls section of this User's Manual for a full description of these OSD controls. NOTE: If you have any problem, please refer to the Troubleshooting section (CD-ROM). To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (Figure RL. NOTE: Handle with care when raising or lowering the monitor screen. Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS. NOTE: Handle with care when tilting and swivelling the monitor screen. Handle with care when removing monitor stand. This LCD monitor is designed for use with a flexible arm. Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor shall only be used with an approved arm (e. Press "SELECT" key Press "SELECT" key Press "SELECT" key Adjust by using "­" or "+" Press "SELECT" key Adjust by using "­" or "+" Selecting TOOL allows you to get into the sub menu. Selecting Factory Preset allows you to reset all OSD control settings back to the factory settings. The RESET button will need to be held down for several seconds to tage effect. [. . . ] RESOLUTION NOTIFIER: This function gives a warning of use with optimized resolution. After power is turned on or when there is a change of input signal or the video signal doesn't have proper resolution, the Resolution Notifier window will open. This function can be disabled in the TOOL menu. oUT OF RANGE: This function gives a recommendation of the optimized resolution and refresh rate. [. . . ]