User manual NEC LT84-LT140

[. . . ] Ultra-Portable Projector MultiSync LT84/LT140 User's Manual IMPORTANT INFORMATION Precautions Please read this manual carefully before using your NEC MultiSync LT84/LT140 Projector and keep the manual handy for future reference. Your serial number is located under the name plate label on the left side of your MultiSync LT84/LT140. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. [. . . ] NOTE: When using a USB mouse, click the mouse button to display the main menu. For other operations, do the same way as you use your PC mouse. Press the vw buttons on the card remote control, the mouse pad on the full function remote control or the projector cabinet to highlight the menu for the item you want to adjust or set. Press the button or the "Enter" button on the projector cabinet or the card remote control or the "Left Click" button on the optional full function remote control to select a submenu or item. Adjust the level or turn the selected item on or off by using "Select" or buttons on the cabinet, the card remote control or the "Mouse pad" on the optional full fucntion remote control. The on-screen slide bar will show you the amount of increase or decrease. The change is stored until you adjust it again. ENTER: Stores the setting or adjustments. General Controls Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed. Turn on the Projector Plug the supplied power cable in the wall outlet. The projector will go into its standby mode and the power indicator will glow amber. Only after you press the "On" button on the projector cabinet or the optional full function remote control will the power indicator turn to green and the projector become ready to use. NOTE: To turn the projector on by plugging in the power cable, use the menu and enable the "Auto Start" feature. Select the Computer, Video Source or PC Card Viewer Press the Source button on the remote control or the projector cabinet to select "Video" (VCR, document camera, or laser disc player), S-Video", "RGB" (computer or DVD with component output) or "PC Card Viewer" (CompactFlash Card) to display the image. Or press the "Menu" button on the remote control or the cabinet and use the menu to select your video source: "Video", "S-Video", "RGB", or "PC Card Viewer". NOTE:The standard video signal NTSC4. 43 and PAL60 must be manually selected from the pull-down menu for Video System on Setup because it cannot be automatically detected. Adjust the Image Size and the Focus Use the Zoom ring to adjust the image size, then use the Focus ring knob to obtain the best focus. Use the "Magnify" button (+) or (-) on the remote control to make the image larger up to 400%. Turning off the Projector First press and hold the POWER button on the cabinet or the "OFF" button on the remote control for a minimum of two seconds. The power indicator will go out. CANCEL: Return to the previous screen without storing settings or adjustments. Repeat steps 2-5 to adjust an additional item, or press "Cancel" on the projector cabinet or the remote control to quit the menu display. Using a USB Mouse Using a USB mouse gives you a smooth operation. A commercially available USB mouse is required. NOTE:There may be some brands of USB mouse that the projector does not support Operate the Menus using the USB mouse Mouse Cursor When connecting a USB mouse to the projector, you get a mouse cursor on the screen. [. . . ] Make sure there are no obstacles between you and the projector. Stand within 10 ­ 17 feet (3 ­ 5 m) of the projector. See page E-34. Image is scrolling vertically, horizontally or both Remote control does not work Status indicator is lit or blinking Cross color in RGB mode · See the Status Light messages above. · If Auto Adjust is off, turn it on. [. . . ]