User manual NEC MULTISYNC LCD400V

[. . . ] MultiSync LCD400V Contents Quick Start Controls Recommended Use Specifications Features Troubleshooting References Limited Warranty 1 2-3 4-5 6-7 8 9 10 11 12 TM ® ® User's Manual 78133331 1 9/25/98, 12:46 PM WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK · DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] · Do not place this product on a sloping or unstable cart, stand or table, as the monitor may fall, causing serious damage to the monitor. · The power cable connector is the primary means of detaching the system from the power supply. The monitor should be installed close to a power outlet that is easily accessible. · When operating the MultiSync LCD monitor with its AC220-240V worldwide power supply, use a power supply cord that matches the power supply voltage of the AC power outlet being used. The power supply cord you use must have been approved by and comply with the safety standards of your country. · Handle with care when transporting. Save packaging for transporting. Immediately unplug your monitor from the wall outlet and refer servicing to qualified service personnel under the following conditions: · · · · · When the power supply cord or plug is damaged. If liquid has been spilled, or objects have fallen into the monitor. If the monitor has been exposed to rain or water. If the monitor has been dropped or the cabinet damaged. If the monitor does not operate normally by following operating instructions. 6 78133331 8 9/25/98, 12:46 PM Recommended Use CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: · For optimum performance, allow 20 minutes for warm-up. · Adjust the monitor height so that the top of the screen is at or slightly below eye level. Your eyes should look slightly downward when viewing the middle of the screen. Automatically Automatically Resolutions Supported Resolution based on horizontal and vertical frequencies only 720 x 400: VGA text Some systems may not support 640 x 480* at 60Hz to 85Hz all modes listed. 800 x 600* at 56Hz to 85Hz 832 x 624* at 75Hz 1024 x 768 at 60Hz to 75Hz . . . . . . . . . . . . . . . . . . . . NEC cites recommended resolution at 60 Hz for optimal display performance. 286 mm/11. 3 inches 214 mm/8. 4 inches AC 100 ­ 120 V/220 ­ 240 V @ 50/60 Hz 0. 7A @ 100 ­ 120 V/0. 4 A @ 220 ­ 240 V 357 mm (W) x 362 mm (H) x 168 mm (D) 14. 1 inches (W) x 14. 3 inches (H) x 6. 7 inches (D) 5 kg 11 lbs 5°C to +35°C/41°F to 95°F 30% to 80% 0 to 10, 000 Feet -10°C to +60°C/14°F to 140°F 10% to 85% 0 to 45, 000 Feet Dependent upon signal timing used, and does not include border area. Active Display Area Power Supply Current Rating Dimensions Weight Horizontal: Vertical: Environmental Considerations Operating Temperature: Humidity: Feet: Storage Temperature: Humidity: Feet: * Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear choppy or lines may appear to be bold. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done. When the interpolated resolution is not an exact multiple of the native resolution, the mathematical interpolation necessary may cause some lines to appear thicker than others. NOTE: Technical specifications are subject to change without notice. 8 78133331 10 9/25/98, 12:46 PM Features Analog Advantage: Capable of displaying unlimited colors in a continuous spectrum, providing a truer representation of color. [. . . ] While NECTECH Products are considered to be compatible with many systems, specific functional implementation by the customers of the Product may vary. Therefore, suitability of a Product for a specific purpose or application must be determined by consumer and is not warranted by NECTECH. For the name of your nearest authorized NECTECH service facility, contact NECTECH at (800) 632-4662. 13 78133331 14 9/25/98, 12:46 PM NEC LCD Series PROPRIETARY NOTICE AND LIABILITY DISCLAIMER The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Technologies and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use and sales rights thereto, except to the extent said rights are expressly granted to others. The NEC Technologies product(s) discussed in this document are warranted in accordance with the terms of the Limited Warranty Statement accompanying each product. [. . . ]