User manual NEC VERSA 5060X SERVICE MANUAL

[. . . ] PROPRIETARY NOTICE AND LIABILITY DISCLAIMER The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Computer Systems Division, Packard Bell NEC, Inc. NECCSD and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use, and sales rights thereto, except to the extent said rights are expressly granted to others. The NECCSD product(s) discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product. However, actual performance of each such product is dependent upon factors such as system configuration, customer data, and operator control. [. . . ] Locate the NOTE battery bay latches on the bottom of the system. Figure 2-4 Battery Release latches 2. Press the small battery bay latch towards the middle of the system to unlock the other latch. 3. Press the other battery bay latch away from the battery. 2-8 Setup and Operation Figure 2-5 Sliding the battery release latches 4. Lift up the end of the installed battery pack closest to the latches. Pull the battery away from the bay and lift it out. Figure 2-6 Removing the battery pack Setup and Operation 2-9 6. To install the charged battery pack, lower the end of the battery pack without connectors into the bay. Figure 2-7 Installing the battery pack 7. Make sure the battery contacts are aligned properly with the connector inside the bay and press down on the battery pack to secure the connection. The large battery bay latch snaps into place. 8. Slide the smaller latch towards the side of the unit to lock the large bat- tery bay latch. 2-10 Setup and Operation Figure 2-8 Replacing the latch Battery Precautions To prevent accidental battery ignition, rupture, or explosion, adhere to the following: To avoid personal injury and property damage, read these battery precautions on handling, charging, and disposing of Li-Ion batteries. NOTE T Keep the battery away from heat sources including direct sunlight, open fires, microwave ovens, and high-voltage containers. Temperatures over 140º F (60ºC) may cause damage. T Do not drop or impact the battery. T Do not use a battery that appears damaged or deformed, has any rust on its casing, is discolored, overheats, or emits a foul odor. T Keep the battery dry and away from water. Setup and Operation 2-11 T Keep metal objects away from battery terminals. Metal objects in contact with the terminals can cause a short circuit and damage. If the battery leaks: T If the battery leaks onto skin or clothing, wash the area immediately with clean water. Battery fluid can cause a skin rash and damage fabric. T If battery fluid gets into eyes, DO NOT rub; rinse with clear water immediately and consult a doctor. T Take extra precautions to keep a leaking battery away from fire. There is a danger of ignition or explosion. Recharging Battery Precautions Adhere to the following precautions when recharging the Li-Ion battery. T Read the instructions that came with the battery charger before charging the battery. T Use only the NEC battery charger designed for your NEC Versa battery type. Different NEC Versa models require different batteries and battery chargers. T Charge the battery for the specified charge time only. T During charging, keep the environmental temperature between 32°F and 104°F (0°C to 40°C). Extending Battery Life While on the road, it is important to be aware of the simple things you can do to extend the life of the system's main battery. One way is to keep the LCD backlight setting at the lowest. You can toggle between these four settings by pressing the function keys, Fn - F5. 2-12 Setup and Operation OPERATING CONTROLS The following section describes system controls, the LEDs, and function keys. Power Button and Status LEDs Your NEC Versa provides a Power button and LEDs to track system status. Descriptions of these features follow the figure. Figure 2-9 Power button and Status LED location T Power Button -- The Power button is located on the chassis just below the LCD. It turns NEC Versa 5000 power on and off. Press the button to turn power on; press it again to turn power off. When power is on, the Power LED to the right of the Power button lights. [. . . ] Information can be obtained from the FaxFlash service 24 hours a day, 7 days a week. Using a touch-tone telephone, call the FaxFlash number, order the desired information through the automated attendant, and FaxFlash will automatically fax the information. Catalogs that list the documents and the document numbers are available. Current catalogs include: T Catalog 1 ­ Telephone Directory and information about Online Services T Catalog 3 ­ Product specifications, warranty policy, UltraCare guidelines, and sales information T Catalog 5 ­ Pro Serva and Express 5800 Server System technical support information T Catalog 6 ­ NEC Ready Systems technical support information T Catalog 7 ­ Powermate Systems technical support information T Catalog 8 ­ NEC Portable System (including Versa Notebooks and MobilePro Handheld Personal computers) technical support information ORDERING INFORMATION FROM FAXFLASH Order information from FaxFlash as follows: 1. [. . . ]