User manual NEC VERSA DOCKING STATION 6000

[. . . ] PROPRIETARY NOTICE AND LIABILITY DISCLAIMER The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Corporation (NEC) and/or its licensors. NEC and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use, and sales rights thereto, except to the extent said rights are expressly granted to others. The NEC product(s) discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product. However, actual performance of each such product is dependent upon factors such as system configuration, customer data, and operator control. [. . . ] Slide the cover all the way onto the docking station. Replace the two screw on the front of the docking station. Adding Options 4-5 Replacing the two screws 6. Replace the thumbscrews on the back of the docking station to secure the cover. Securing the cover 7. Replace the two screws next to the docking connector. EXPANSION BOARDS You can install three full-size or half-size PCI-bus or AT-style expansion boards in the NEC Docking Station 6000. Before beginning the installation, check the documentation that came with the board. If you have any switches to set on the board, do so before starting this procedure. 4-6 Adding Options Precautions Always remove expansion boards from the shipping material very carefully. Static discharge can damage board components. Take the following precautions when handling boards: n Avoid carpets in cool, dry areas. n Before handling a board, discharge any static electricity by touching a grounded metal object. n Always hold a board by its edges. Avoid touching the components on the board. Slot Locations Slot locations for expansion boards are shown in the following figure. Expansion slot locations These slots accommodate the following expansion board types: n One slot accepts any industry-standard PCI-bus board. n One slot accepts any industry standard 8- or 16-bit ISA expansion board. n One slot accepts either a PCI-bus or ISA expansion board. Adding Options 4-7 PCI and ISA slot locations Installation Follow these steps to install an expansion board in the docking station. 1. Prepare for board installation as follows: n Disconnect and remove the NEC Versa from the docking station. n Turn off and unplug the docking station. n Disconnect any peripheral devices connected to the docking station. See "Cover Removal" earlier in this section for information on removing the cover. n Position the docking station so you have access to the side where the expansion slots are located. CAUTION Be careful not to drop anything into the docking station. Doing so can damage the unit. 4-8 Adding Options 2. Locate and remove the screw that attaches the slot cover to the docking station. Removing the slot cover screw 3. Locate the expansion slot connectors inside the docking station. Hold the board by its edges, component side up, and insert it into the slot. If installing a full-size board, fit the board into the guide at the front of the docking station. Adding Options 4-9 Aligning the board edge and connector 6. Press the board firmly until it is securely seated in the connector. You may have to rock the board side-to-side. 7. [. . . ] Disconnect the modem until the source of the problem is determined and repairs are made. If this is not done, the telephone company may temporarily disconnect service. The telephone company may make changes in its technical operations and procedures. If such changes affect the compatibility or use of the modem, the telephone company is required to give adequate notice of the changes. [. . . ]