User manual NEC VERSA MEDIADOCK SERVICE MANUAL

[. . . ] PROPRIETARY NOTICE AND LIABILITY DISCLAIMER The information disclosed in this document, including all designs and related materials, is the valuable property of NEC Corporation (NEC) and/or its licensors. NEC and/or its licensors, as appropriate, reserve all patent, copyright and other proprietary rights to this document, including all design, manufacturing, reproduction, use, and sales rights thereto, except to the extent said rights are expressly granted to others. The NEC product(s) discussed in this document are warranted in accordance with the terms of the Warranty Statement accompanying each product. However, actual performance of each such product is dependent upon factors such as system configuration, customer data, and operator control. [. . . ] Press Enter or click "OK" to accept the default subdirectory MEDIADOK. The utility copies the required software into the specified subdirectory. n n 7. If you are using a Versa P, exit Windows and reboot your system to activate the CD-ROM. The Versa P and MediaDock are now ready to use together. If you are using an UltraLite Versa, Versa E, Versa M, or Versa V, proceed as follows at the prompt: n Remove the setup diskette, insert Audio Applications diskette 1 into the drive, and press Enter. Setup and Operation 2-15 n The first audio screen tells you to close any applications that are running. If you followed the instructions given here, you already closed open applications. Just click "Continue" to proceed. If you did not follow these instructions, click "Exit. " Go back to the beginning of this section, "MediaDock Setup Utility, " and start over. 8. When prompted, select installation operations in the following order. n Driver installation Click the "Driver Installation" button. At the prompt, select "Automatic Board Configuration. " At the next prompt, click the "Install Software" button to install the audio software. n Software installation Press Enter or click "OK" to accept the default directory PCAUDIO for loading the audio software. Press Enter again to create the directory. Choose "Complete Installation" for the type of installation to follow. At the prompt, insert Audio Applications diskette 2 into the drive and press Enter. At the prompt, click "Restart Windows" to reboot Windows (this activates the MediaDock audio). 10. Exit Windows and press the Power button to reboot the system and activate the CD-ROM drivers. 11. See the following sections for operation information. n See "MediaDock Setup Software" for information about using MediaDock software. See "CD-ROM Use" for information about using CDs in the MediaDock. n Software Use This section describes how to use the software that the MediaDock Setup utility loads in the Versa. n At start up, the Versa lets you choose a configuration to use. See "Choosing a Configuration" for instructions. n Versa M users can use either the MediaDock sound system or the Versa sound system. See "Using the Audio Switcher Utility" later in this section for more information. 2-16 Setup and Operation n Some programs run from MS-DOS instead of Windows. Use the information un- der "Using DOS-Based Programs" to enable and control MediaDock sound from MS-DOS applications. Choosing a Configuration After setting up the MediaDock software, your Versa boot-up differs from its original procedure. The new boot up sequence lets you choose which configuration to use. [. . . ] At the prompt, press Enter to save now. Appendix B contains a sample AUTOEXEC. BAT file. 5. To continue software setup, go to "Running the MediaDock Setup Utility" in Section 2. Appendix B System Files This appendix provides samples of a CONFIG. SYS and an AUTOEXEC. BAT file. The files shown reflect the contents of files after the MediaDock Setup utility is run. [. . . ]