User manual NEC VT610

[. . . ] Projector WT615/WT610 User's Manual The WT615 projector is not distributed in the U. S. A or Canada. Important Information Safety Cautions Precautions Please read this manual carefully before using your NEC WT615/WT610 Projector and keep the manual handy for future reference. Your serial number is located on the right side of your projector. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. [. . . ] Displays how many hours the lamp has been used. Displays the status of errors occurring within the projector. 65 4. Convenient Features Using the Projector to Operate a Computer Connected on a Network (Desktop Control Utility 1. 0) When Desktop Control Utility 1. 0 on the included User Supportware 2 CD-ROM is installed on the computer, that computer can be operated using the projector over a network. For example, say you have a PowerPoint file on a computer in your office that you want to use for a presentation at a meeting. If the computer in the office is connected by LAN to the projector in the meeting room, the projector can be operated to project the image of the desktop of the computer (Windows 2000 or XP) in the office and display the PowerPoint file during the meeting. This eliminates the need for taking the computer from the office to the meeting room. Meeting room Office Disclaimer You can use the Desktop Control Utility 1. 0 to operate a computer located in a separate room from the projector over a network. This means there might be potential security risks that you may be exposed to which could cause damage by unauthorized access or illegal use. We recommend you take some measures to prevent third parties from unauthorized access to your data or information. We share neither liability nor responsibility to any loss or damages arising from information leak or power down without notice. NOTE: In Windows operating system, click "Control Panel" "Power Options" "System Standby" "Never". This will disconnect a LAN connection when the computer goes in standby mode. NOTE: To use the Desktop Control Utility 1. 0, you need to have a USB mouse inserted into the USB port of the projector. The WT615 does not require connection with a USB mouse because the electronic pen can be used for a USB mouse. This section explains the operation by using a USB mouse. 66 4. Convenient Features Operations on the Computer 1. Connect the computer to the LAN and make the required settings. Install Desktop Control Utility 1. 0 on the computer. · · For instructions on installation, refer to the included "Wired and Wireless Network Setup Guide". For instructions on operating the software, see the Desktop Control Utility 1. 0's help file. 3. Prepare the documents to be presented at the meeting and save them on the computer. The Startup password window appears. Window at the first startup Window after entering your startup password Important: · Your startup password will be required each time you start Desktop Control Utility 1. 0. Input the startup password and click "OK". The "Current password" input window appears. If you forget or lost your startup password, install the program again. NOTE: The "Current password" will be changed each time you start Desktop Control Utility 1. 0. [. . . ] Accident, misuse, abuse, neglect, improper ventilation, fire, dust, smoke, water, lightning or other acts of nature, unauthorized product modification, or failure to follow instructions supplied with the product. Repair or attempted repair by anyone other than a NEC Solutions authorized service center. Any shipment of the product (claims must be presented to the carrier). Any other cause which does not relate to a product defect. [. . . ]