User manual NEFF D4672X0

[. . . ] de en fr nl it es el Gebrauchs- und Montageanweisung Operating and installation instructions Notice de montage et d'utilisation Gebruiks- en montageaanwijzing Istruzioni per l'uso e l'installatore Instrucciones de uso y montaje de en fr nl it es el de en fr nl Seite page page pagina 03 ­ 15 16 ­ 28 29 ­ 41 42 ­ 54 it es el pagina página 55 ­ 67 68 ­ 80 81 ­ 93 Abb. 430 2 Operating instructions: Description of appliance Operating modes This can be achieved if the combustion air is able to flow through non-lockable openings, e. g. in doors, windows and in conjunction with an air supply/air-intake wall box or by other technical procedures such as reciprocal interlocking. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Clean the extractor hood with a hot soap solution or a mild window cleaner. Do not scrape off dried-on dirt but wipe off with a damp cloth. Do not use scouring agents or abrasive sponges. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Caution: Ensure that the kitchen is adequately ventilated. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Do not use aggressive, acidic or caustic cleaners. Do not use abrasive agents. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. Remove the bulb ring with a screwdriver or similar tool. 3. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Take hold of the bulb with a clean cloth. 4. Restore the power by inserting the mains plug or switching on the fuse. Note: If the light does not function, check that the bulbs have been inserted correctly. 21 Installation Instructions: Important information Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. [. . . ] Using the enclosed template O, mark the attachment points on the wooden strip and make holes with a bradawl. 10 mm in depth. Weight in kg: Exhaust air 13, 0 Circulating air 13, 5 2. Align handle moulding and screw to the appliance. We reserve the right to construction changes within the context of technical development. 27 Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the power cord are colourcoded as follows: Green and Yellow ­ Earth Blue ­ Neutral Brown ­ Live If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. Connect the green and yellow (Earth) wire to the terminal in the plug marked `E' or with the symbol ( ), or coloured green or green and yellow. [. . . ]