User manual NEFF D5855

[. . . ] 7 . 7 . 7 . 8 . 9 10 10 10 12 12 13 13 16 16 16 17 17 17 17 18 19 19 19 19 20 21 22 22 22 22 23 24 Operating instructions. . 3 Dear customer, Congratulations on your choice and thank you for purchasing one of our appliances. This practical, modern and functional appliance is manufactured using materials of the highest quality which are subject to strict quality control checks throughout the entire manufacturing process. The appliance is meticulously tested to ensure that it meets your demands and produces perfect cooking results. [. . . ] When connecting the cooktop ensure that the earth wire is connected first and that all wires are connected to the correct terminals. 4. Gas During the planning stage, consider the position of supply connections. The cooktop must be connected to the gas supply with upstream connection of an isolation valve in accordance with the respectively valid regulations. We recommend that the isolation valve be fitted prior to the cooktop to enable isolation of cooktop from gas supply. The valve must be easily accessible at all times. To find out the factory set gas type, see bottom of cooktop next to gas connection. Remove plastic cap from gas supply line prior to installation. Fit regulator (N. G. ) or a test point (Universal LPG) directly to the R 1/2'' connection as per Fig. Direction of gas flow is indicated on the rear of the regulator. For position of the inlet connection refer Fig. 1. Use pipe compound or thread sealant, properly theaded pipes and careful assembly procedure so that there is no cross threading, etc. , which might cause damage or leakage. It is important that all the seals are refitted to form a seal. These devices are essential for the correct operation of the appliance as they prevent liquids and dirt from entering the appliance. In the event of a malfunction, change the whole tap. Fig. After finishing, the sticker indicating the new type of gas must be placed close to the specifications plate. 14 Operating instructions Burner locations 4 1 5 4 1 5 6 2 3 3 2 7 4 1 2 3 4 5 6 7 Pan supports Control knobs Auxiliary burner (up to 1 kW) Semi-rapid burner (up to 1, 75 kW) Rapid burner (up to 3 kW) Double-flame burner (up to 3, 3 kW) Double-flame burner (up to 5 kW) There are indications to show which burner each control knob operates. 12 The gas burners Operation It is essential to ensure that all the burner parts and pan supports are correctly installed for the appliance to work correctly. 14 Switching on automatically If your cooktop can be switched on automatically (ignition sparkers): 15 1. Press the chosen burner control knob and turn it anticlockwise to the maximum power setting. While the control knob is still pressed down, sparks are produced on all burners. The flame ignites (it is no longer necessary to press down the control knob). Turn the control knob to the required setting. If it does not come on, turn the control knob to the off setting and repeat the steps above. [. . . ] If your hob is fitted with a glass or aluminium panel, never use a knife, scraper or similar to clean the point where it joins the metal. Maintenance Always clean off any liquid as soon as it is spilt: you will save yourself any unnecessary effort. Where possible, do not allow salt to come into contact with the surface of the electric hob. The ring cover of the double or triple flame burner and stainless steel parts such as hotplate rings, top sheet and the area around the burners may become discoloured over time. [. . . ]