User manual NEFF D8762N0GB

[. . . ] Installation instructions and how to use and look after your built-in cooker hoods D8662 / D8762 / D8962 NEFF (UK) Ltd Fig. 550 2 Operating Instructions Appliance description Chimney panelling Light / fan switches Operating modes This can be achieved if the combustion air is able to flow through non-lockable openings, e. g. in doors, windows and in conjunction with an air supply/air-intake wall box or by other technical procedures such as reciprocal interlocking. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Insert the clean filters back into the hood. 3. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. 6 Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! Clean the extractor hood with a hot soap solution or a mild window cleaner. Do not scrape off dried-on dirt but wipe off with a damp cloth. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Caution: Ensure that the kitchen is adequately ventilated. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. We recommend our stainless steel cleaner no. See enclosed service booklet for order address. [. . . ] Before undertaking any repairs, always disconnect the extractor hood from the electricity supply. This extractor hood corresponds to EC regulations concerning RF interference suppression. 11 Installation This extractor hood is intended to be mounted onto the kitchen wall. Remove the grease filter (refer to Operating Instructions). Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. [. . . ]