User manual NEFF ICK68X

[. . . ] 9000337838 (1W08Z6) 00 8802 en Installation Instructions please keep 1 2 3 4 5 6 EN Important notes J Safety in use is only guaranteed if the technical installation of the hob has been carried out correctly and in accordance with the installation instructions. The installation technician shall be liable for any damage caused as a result of incorrect installation. J Only an authorised technician is able to connect the appliance. [. . . ] J If the hob is installed above a drawer, it is recommended to use an intermediate support, as metal objects stored in the drawer could reach high temperatures as a result of the circulating air coming from the hob's ventilation system. J A strip of wood can be used as an intermediate support or an appropriate accessory can be obtained from our After-Sales Service. The reference code for this accessory is 476609 J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. J The gap between the aperture and the side wall must be at least: 40 mm. It is not recommended that the hob be placed between two side walls but, if this is the case, a gap of at least 200 mm should also be left on one side. J The worktop where the hob is installed should be: 30 mm thick, if it is installed above an oven, 20 mm thick, if it is installed without an oven or above a drawer. J Taking into account the hob ventilation: - an aperture must be cut in the top section of the back of the kitchen unit, 550 mm wide and 45 mm high (figure 2). - there must be a gap of 20 mm between the back of the kitchen unit and the kitchen wall (figure 4). - if the hob is installed above a drawer, allow a gap of 65 mm between the drawer and the top section of the hob. J If a wooden panel is installed as an intermediate support, this should be 5 mm thick. The following requirements must also be taken into account: - allow a gap of 65 mm between the wooden panel and the top section of the hob. - the aperture cut in the back of the panel (figure 2) must be sufficiently deep to enable the hob cable to be fed through it (figure 3). The wooden panel must be as airtight as possible, to separate the drawer from the area in which the hob air is circulated. To ensure this is the case, the dimensions of the panel must be adjusted to fit the measurements of the kitchen unit housing in which the hob will be installed. Installing and connecting the hob Figure 5 J See the rating plate for the voltage. J Connect according to the connection diagram only. [. . . ] J Surfaces which have been cut should be sealed so that they are heat resistant and so that they do not swell when moist. J The kitchen units to be fitted must resist temperatures of up to 90ºC. Removing the hob Disconnect the cooker from the power supply. Push out the hob from below. Connection diagram - Figure 6 1. [. . . ]