User manual NEFF K7791X0

[. . . ] K7791X0. . 9000 291 220 (8707) en Installation Instructions Content Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation Possibilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stand alone appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stand alone appliance with dividing wall . . . . . . . . . . . . . . . . . [. . . ] To do this, loosen the fastening screws and remove the stops. Note: Keep the stops safe as otherwise they may become lost. ­ The set supplied, contains fastening screws for various subsurfaces. Select the fastening screws corresponding to the local conditions. If it is not possible to securely fasten the anti-tilt ribs and consequently, not possible to securely fasten the appliance using the fastening screws supplied, select another suitable method for securely fastening the anti-tilt ribs. In the case of some fitted shapes, it may be necessary to screw in at an angle the wood screws used to fasten the anti-tilt ribs to the rear wall. ­ 11 Subsurface wooden floors The wood screws (5 x 60 mm and 4 x 15 mm) which are supplied should be used for wooden floors. Drilling guide holes: 3 mm for woodscrews (5 x 60 mm) 2 mm for woodscrews (4 x 15 mm) Make sure that the screws 5 x 60 grip at least 19 mm into the solid subsurface. By hand, screw into the dowel until you can feel resistance. Strike the dowel and screw into the hole until the head of the screw has a 13 mm distance to the anti-tilt securing device. Screw tightly. Tightly screw the anti-tilt ribs. Re-examine to make sure that the screws are firmly tightened. Subsurface concrete Warning!When installing or working with floor anchors always use protective glasses and other protective equipment or protective clothing ­ risk of injury!Floor anchors are not suitable for use in connection with lightweight construction masonry, breeze blocks or tiles. Never use floor anchors in fresh concrete which has not hardened. In drilling holes for these floor anchors, do not use core drills. Additionally use the (5 x 60 mm und 4 x 15 mm) woodscrews supplied. Drill a hole with a 10 mm diameter having a depth a little more than the raising depth. Clean the hole or drill a little deeper. Additionally use the supplied wood screws (if the subsurface allows). 6. Attaching an additional anti-tilt mechanism Important note: As far as possible, always screw the wooden plank to the rear wall of the niche. If the anti-tilt ribs cannot be fastened securely, a wooden beam can be used above the appliance as an alternative anti-tilt mechanism. Care should be taken that there is not a gap between the appliance and the wooden beam. Cut the wooden plank to the required length (cross section min. [. . . ] Re-examine the dimensions of the crack continuously. Screw the nuts on the adjusting rib tightly. This way, the lateral adjustment of the door is fixed. 24. Screw on the lower fixing angle Screw on the lower fastening angles from the auxiliary set. Pre-drill holes into the furniture door! [. . . ]