User manual NEFF S41E50N0GB

[. . . ] HQ 23(5$7, 1* , 16758&7, 216 ', 6+:$6+(5 Q 5HVHW VHF 6WDUW en Table of contents Washing the dishes . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . 16 16 16 16 17 17 17 17 17 18 18 18 18 19 19 19 19 20 20 21 21 21 22 22 23 24 24 24 25 25 25 25 26 26 26 27 27 27 27 27 Safety instructions . [. . . ] The factory set value : is lit on the digital display H. To change the setting: ­ Rotate programme selector 8 until the required value is indicated on the digital display H. : Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press button P until the digital display H jumps to : . ­ Press button P until the displayed time corresponds with your requirements. ­ Press START button @, timer programming is activated. ­ To delete the preselected starting time, press the button P until is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display H. Switching off the appliance Short time after the end of the programme: ­ Switch off ON/OFF switch (. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. 17 en ã=Warning Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) ­ Close the door. ­ Press and hold down the START button @. ­ Rotate programme selector 8 until : is indicated on the digital display H. The factory-set value : is lit on the digital display H (intensive drying off). Change the setting as follows: ­ By rotating the programme selector 8, you can switch intensive drying on : or off : . The set value is saved. At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Switch off ON/OFF switch (. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. Terminating the programme (Reset) ­ Press START button @ for approx. ­ The programme sequence lasts approx. On the digital display H is indicated : . [. . . ] ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. [. . . ]