User manual NEFF S52T69X1EU

[. . . ] ·:< ·:< ·:<^ A BC h : min. ­ Hold down programme button A and press START button until H:0. . . The LED for button A flashes and the factory set value of H:04 is indicated on the digital display. Each time the button is pressed the set value increases by one setting; when the value reaches H:07, the display jumps back to H:00 (off). [. . . ] * half normal load 1:40-2:15 1, 30-1, 60 11-15 0:15 0, 05 4 - Additional options ** Switch off the appliance Everything o. k. is obtained by increased energy consumption at a constant cleaning performance. § Half load . . . for a few items, saves water, energy and time. Ï Intensive zone . . . Washing pressure and washing temperature are increased slightly. · Hygiene . . . the temperature is increased during the final rinse process. This increases the hygiene status. ¿ . . . improves the drying result by increased temperature in the final rinse. (Please take care with delicate dishes. ) ** depending on model Maintenance and care Filters . . . Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . Screw on filter system NOTE MARK! Cleaning waste water pump ­ ­ ­ ­ Pull out the mains plug. Check area around the fan impeller for foreign objects. Remove blockages/ deposits. pull lower arm upwards . . . unscrew upper arm . . . clean spray nozzles under running water (if required use toothpicks) . . . insert lower arm . . . A B 2 3 1 screw on upper arm tightly CLICK! Rectifying minor faults yourself . . . Fault Display "6" is lit . . . If the flow rate is less, replace the supply fitting. Install supply hose without kinks. More information can be found in the operating instructions Possible causes Supply fitting jammed or calcified Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Remedial action Separate the utensils, prevent contact points. [. . . ] Unplug appliance. Residual water in the appliance The programme has not yet ended Switch on and close the appliance or terminate the programme (see Terminating the programme). Glasses not dishwasher-proof Use dishwasher-proof glasses. Use a detergent suitable for glasses. Rust on the cutlery Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust Use dishwasher-proof cutlery. Never wash rusting parts in the appliance. Plastic/utensils discoloured Too little detergent Discoloration caused by food colourings (tomato sauce) Follow manufacturer's instructions (detergent). [. . . ]