User manual NEFF S71M68X0EU

[. . . ] HQ 23(5$7, 1* , 16758&7, 216 ', 6+:$6+(5 Q 6WDUW $ % & 5HVHW VHF en Table of contents Washing the dishes . Optical display while the programme is running . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . [. . . ] To change the setting, ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Press START button `, the set value is saved. ­ Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 16 en Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . Appliance does not switch off automatically : Off after 1 min : Off after 120 min ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). : ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ To continue the programme, switch on the ON/OFF switch ( again. ­ Close the door. Terminating the programme (Reset) ­ Open the door. On the digital display h is indicated : . ­ Close the door. Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Turn off the tap (not applicable if AquaStop fitted). ­ Remove the utensils when they have cooled down. 17 en Changing the programme When the START button ` has been pressed, the programme cannot be changed. [. . . ] ­ The connection may be modified by technicians only. ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. [. . . ]