User manual NEFF T18PT16X0

[. . . ] Switching the childproof lock on and off . Additional information on products, accessories, replacement parts and services can be found at www. The instruction and installation manual, as well as the appliance certificate, in a safe place for later use or for subsequent owners. Check the appliance for damage after unpacking it. [. . . ] Switch on the hob using the main switch. Touch the oe symbol and U at the same time for 4 Touch the U symbol repeatedly until the display for The desired hotplate lights up. Press the oe (-) and (+) x buttons to select the heat Note: You can place the twist knob back on the twistpad at any time. 1Operating the appliance In Operatingtheapliance this section, you can find out how to set the hotplates. The table shows heat settings and cooking times for various meals. Switching the hob on and off The main switch is used to switch the hob on and off. Switching on the appliance Touch the # symbol. The A display above the main switch lights up. The control displays and the heat setting displays < light up. Switching off the appliance Touch the # symbol until the A display above the main switch and the displays goes out. The residual heat indicator remains on until the hotplates have cooled down sufficiently. Notes The hob will switch itself off automatically once all Hotplates have been switched off for a while (1060 seconds). The settings remain stored for 4 seconds after the hob has been switched off. If you switch it on again during this time, the hob will operate using the previously stored settings. setting a hotplate Use the twist knob to set the desired cooking time. Heat setting 1 = lowest setting Heat setting 9 = highest setting There is an intermediate setting between each heat setting. Set the heat setting The hob must be switched on. To do this, touch the twist knob In the appropriate area for the required hotplate. Within the next 10 seconds, turn the twist knob until The desired heat setting appears in the heat setting display. Changing the heat setting: Select the hotplate and set the new heat setting. Switching off the hotplate: Select the hotplate and set it to <. After about 10 seconds, the residual heat indicator appears. [. . . ] The fault display goes out shortly afterwards. When " goes out, you can continue cooking. You can switch the hotplate back on again immediately. Switching off the demo mode: Disconnect the appliance for 30 seconds from the power supply (switch off the household fuse or the circuit breaker in the fuse box). [. . . ]